block, bfq: reset inject limit when think-time state changes

block, bfq: reset inject limit when think-time state changes

Until the base value of the request service times gets finally
computed for a bfq_queue, the inject limit does depend on the
think-time state (short|long). The limit must be 0 or 1 if the think
time is deemed, respectively, as short or long. However, such a check
and possible limit update is performed only periodically, once per
second. So, to make the injection mechanism much more reactive, this
commit performs the update also every time the think-time state
changes.

In addition, in the following special case, this commit lets the
inject limit of a bfq_queue bfqq remain equal to 1 even if bfqq's
think time is short: bfqq's I/O is synchronized with that of some
other queue, i.e., bfqq may receive new I/O only after the I/O of the
other queue is completed. Keeping the inject limit to 1 allows the
blocking I/O to be served while bfqq is in service. And this is very
convenient both for bfqq and for the total throughput, as explained
in detail in the comments in bfq_update_has_short_ttime().

Reported-by: Srivatsa S. Bhat (VMware) <srivatsa@csail.mit.edu>
Tested-by: Srivatsa S. Bhat (VMware) <srivatsa@csail.mit.edu>
Signed-off-by: Paolo Valente <paolo.valente@linaro.org>
Signed-off-by: Jens Axboe <axboe@kernel.dk>