Currently be3-native mode is requested only in probe(). It must be requested, each time the card is reset either after an EEH error or after
sleep/hibernation.
Also, the be_cmd_check_native_mode() is better named be_cmd_req_native_mode()
Signed-off-by: Sathya Perla <sathya.perla@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
}
/* Uses mbox */
-int be_cmd_check_native_mode(struct be_adapter *adapter)
+int be_cmd_req_native_mode(struct be_adapter *adapter)
{
struct be_mcc_wrb *wrb;
struct be_cmd_req_set_func_cap *req;
extern void be_detect_dump_ue(struct be_adapter *adapter);
extern int be_cmd_get_die_temperature(struct be_adapter *adapter);
extern int be_cmd_get_cntl_attributes(struct be_adapter *adapter);
-extern int be_cmd_check_native_mode(struct be_adapter *adapter);
+extern int be_cmd_req_native_mode(struct be_adapter *adapter);
extern int be_cmd_get_reg_len(struct be_adapter *adapter, u32 *log_size);
extern void be_cmd_get_regs(struct be_adapter *adapter, u32 buf_len, void *buf);
int status;
u8 mac[ETH_ALEN];
+ be_cmd_req_native_mode(adapter);
+
cap_flags = en_flags = BE_IF_FLAGS_UNTAGGED |
BE_IF_FLAGS_BROADCAST |
BE_IF_FLAGS_MULTICAST;
be_cmd_if_destroy(adapter, adapter->if_handle, 0);
+ adapter->be3_native = 0;
+
/* tell fw we're done with firing cmds */
be_cmd_fw_clean(adapter);
return 0;
if (status)
return status;
- be_cmd_check_native_mode(adapter);
-
if ((num_vfs && adapter->sriov_enabled) ||
(adapter->function_mode & 0x400) ||
lancer_chip(adapter) || !be_physfn(adapter)) {