As per Eric Dumazet's previous patches:
(see commit (
24d2e4a50737) - tg3: use napi_complete_done())
Quoting verbatim:
Using napi_complete_done() instead of napi_complete() allows
us to use /sys/class/net/ethX/gro_flush_timeout
GRO layer can aggregate more packets if the flush is delayed a bit,
without having to set too big coalescing parameters that impact
latencies.
</end quote>
Tested
configuration: low latency via ethtool -C ethx adaptive-rx off
rx-usecs 10 adaptive-tx off tx-usecs 15
workload: streaming rx using netperf TCP_MAERTS
igb:
MIGRATED TCP MAERTS TEST from 0.0.0.0 (0.0.0.0) port 0 AF_INET to 10.0.0.1 () port 0 AF_INET : demo
...
Interim result: 941.48 10^6bits/s over 1.000 seconds ending at
1440193171.589
Alignment Offset Bytes Bytes Recvs Bytes Sends
Local Remote Local Remote Xfered Per Per
Recv Send Recv Send Recv (avg) Send (avg)
8 8 0 0
1176930056 1475.36 797726 16384.00 71905
MIGRATED TCP MAERTS TEST from 0.0.0.0 (0.0.0.0) port 0 AF_INET to 10.0.0.1 () port 0 AF_INET : demo
...
Interim result: 941.49 10^6bits/s over 0.997 seconds ending at
1440193142.763
Alignment Offset Bytes Bytes Recvs Bytes Sends
Local Remote Local Remote Xfered Per Per
Recv Send Recv Send Recv (avg) Send (avg)
8 8 0 0
1175182320 50476.00 23282 16384.00 71816
i40e:
Hard to test because the traffic is incoming so fast (24Gb/s) that GRO
always receives 87kB, even at the highest interrupt rate.
Other drivers were only compile tested.
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
if (work_done < budget) {
if (likely(adapter->itr_setting & 3))
e1000_set_itr(adapter);
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
if (!test_bit(__E1000_DOWN, &adapter->flags))
e1000_irq_enable(adapter);
}
if (work_done < weight) {
if (adapter->itr_setting & 3)
e1000_set_itr(adapter);
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
if (!test_bit(__E1000_DOWN, &adapter->state)) {
if (adapter->msix_entries)
ew32(IMS, adapter->rx_ring->ims_val);
napi_gro_receive(&q_vector->napi, skb);
}
-static bool fm10k_clean_rx_irq(struct fm10k_q_vector *q_vector,
- struct fm10k_ring *rx_ring,
- int budget)
+static int fm10k_clean_rx_irq(struct fm10k_q_vector *q_vector,
+ struct fm10k_ring *rx_ring,
+ int budget)
{
struct sk_buff *skb = rx_ring->skb;
unsigned int total_bytes = 0, total_packets = 0;
q_vector->rx.total_packets += total_packets;
q_vector->rx.total_bytes += total_bytes;
- return total_packets < budget;
+ return total_packets;
}
#define VXLAN_HLEN (sizeof(struct udphdr) + 8)
struct fm10k_q_vector *q_vector =
container_of(napi, struct fm10k_q_vector, napi);
struct fm10k_ring *ring;
- int per_ring_budget;
+ int per_ring_budget, work_done = 0;
bool clean_complete = true;
fm10k_for_each_ring(ring, q_vector->tx)
else
per_ring_budget = budget;
- fm10k_for_each_ring(ring, q_vector->rx)
- clean_complete &= fm10k_clean_rx_irq(q_vector, ring,
- per_ring_budget);
+ fm10k_for_each_ring(ring, q_vector->rx) {
+ int work = fm10k_clean_rx_irq(q_vector, ring, per_ring_budget);
+
+ work_done += work;
+ clean_complete &= !!(work < per_ring_budget);
+ }
/* If all work not completed, return budget and keep polling */
if (!clean_complete)
return budget;
/* all work done, exit the polling mode */
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
/* re-enable the q_vector */
fm10k_qv_enable(q_vector);
bool clean_complete = true;
bool arm_wb = false;
int budget_per_ring;
- int cleaned;
+ int work_done = 0;
if (test_bit(__I40E_DOWN, &vsi->state)) {
napi_complete(napi);
budget_per_ring = max(budget/q_vector->num_ringpairs, 1);
i40e_for_each_ring(ring, q_vector->rx) {
+ int cleaned;
+
if (ring_is_ps_enabled(ring))
cleaned = i40e_clean_rx_irq_ps(ring, budget_per_ring);
else
cleaned = i40e_clean_rx_irq_1buf(ring, budget_per_ring);
+
+ work_done += cleaned;
/* if we didn't clean as many as budgeted, we must be done */
clean_complete &= (budget_per_ring != cleaned);
}
q_vector->arm_wb_state = false;
/* Work is done so exit the polling mode and re-enable the interrupt */
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
if (vsi->back->flags & I40E_FLAG_MSIX_ENABLED) {
i40e_update_enable_itr(vsi, q_vector);
} else { /* Legacy mode */
bool clean_complete = true;
bool arm_wb = false;
int budget_per_ring;
- int cleaned;
+ int work_done = 0;
if (test_bit(__I40E_DOWN, &vsi->state)) {
napi_complete(napi);
budget_per_ring = max(budget/q_vector->num_ringpairs, 1);
i40e_for_each_ring(ring, q_vector->rx) {
+ int cleaned;
+
if (ring_is_ps_enabled(ring))
cleaned = i40e_clean_rx_irq_ps(ring, budget_per_ring);
else
cleaned = i40e_clean_rx_irq_1buf(ring, budget_per_ring);
+
+ work_done += cleaned;
/* if we didn't clean as many as budgeted, we must be done */
clean_complete &= (budget_per_ring != cleaned);
}
q_vector->arm_wb_state = false;
/* Work is done so exit the polling mode and re-enable the interrupt */
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
i40e_update_enable_itr(vsi, q_vector);
return 0;
}
#endif /* CONFIG_IGB_DCA */
static int igb_poll(struct napi_struct *, int);
static bool igb_clean_tx_irq(struct igb_q_vector *);
-static bool igb_clean_rx_irq(struct igb_q_vector *, int);
+static int igb_clean_rx_irq(struct igb_q_vector *, int);
static int igb_ioctl(struct net_device *, struct ifreq *, int cmd);
static void igb_tx_timeout(struct net_device *);
static void igb_reset_task(struct work_struct *);
struct igb_q_vector,
napi);
bool clean_complete = true;
+ int work_done = 0;
#ifdef CONFIG_IGB_DCA
if (q_vector->adapter->flags & IGB_FLAG_DCA_ENABLED)
if (q_vector->tx.ring)
clean_complete = igb_clean_tx_irq(q_vector);
- if (q_vector->rx.ring)
- clean_complete &= igb_clean_rx_irq(q_vector, budget);
+ if (q_vector->rx.ring) {
+ int cleaned = igb_clean_rx_irq(q_vector, budget);
+
+ work_done += cleaned;
+ clean_complete &= (cleaned < budget);
+ }
/* If all work not completed, return budget and keep polling */
if (!clean_complete)
return budget;
/* If not enough Rx work done, exit the polling mode */
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
igb_ring_irq_enable(q_vector);
return 0;
skb->protocol = eth_type_trans(skb, rx_ring->netdev);
}
-static bool igb_clean_rx_irq(struct igb_q_vector *q_vector, const int budget)
+static int igb_clean_rx_irq(struct igb_q_vector *q_vector, const int budget)
{
struct igb_ring *rx_ring = q_vector->rx.ring;
struct sk_buff *skb = rx_ring->skb;
if (cleaned_count)
igb_alloc_rx_buffers(rx_ring, cleaned_count);
- return total_packets < budget;
+ return total_packets;
}
static bool igb_alloc_mapped_page(struct igb_ring *rx_ring,
/* If not enough Rx work done, exit the polling mode */
if (work_done < budget) {
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
if (adapter->requested_itr & 3)
igbvf_set_itr(adapter);
container_of(napi, struct ixgbe_q_vector, napi);
struct ixgbe_adapter *adapter = q_vector->adapter;
struct ixgbe_ring *ring;
- int per_ring_budget;
+ int per_ring_budget, work_done = 0;
bool clean_complete = true;
#ifdef CONFIG_IXGBE_DCA
else
per_ring_budget = budget;
- ixgbe_for_each_ring(ring, q_vector->rx)
- clean_complete &= (ixgbe_clean_rx_irq(q_vector, ring,
- per_ring_budget) < per_ring_budget);
+ ixgbe_for_each_ring(ring, q_vector->rx) {
+ int cleaned = ixgbe_clean_rx_irq(q_vector, ring,
+ per_ring_budget);
+
+ work_done += cleaned;
+ clean_complete &= (cleaned < per_ring_budget);
+ }
ixgbe_qv_unlock_napi(q_vector);
/* If all work not completed, return budget and keep polling */
return budget;
/* all work done, exit the polling mode */
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
if (adapter->rx_itr_setting & 1)
ixgbe_set_itr(q_vector);
if (!test_bit(__IXGBE_DOWN, &adapter->state))
container_of(napi, struct ixgbevf_q_vector, napi);
struct ixgbevf_adapter *adapter = q_vector->adapter;
struct ixgbevf_ring *ring;
- int per_ring_budget;
+ int per_ring_budget, work_done = 0;
bool clean_complete = true;
ixgbevf_for_each_ring(ring, q_vector->tx)
else
per_ring_budget = budget;
- ixgbevf_for_each_ring(ring, q_vector->rx)
- clean_complete &= (ixgbevf_clean_rx_irq(q_vector, ring,
- per_ring_budget)
- < per_ring_budget);
+ ixgbevf_for_each_ring(ring, q_vector->rx) {
+ int cleaned = ixgbevf_clean_rx_irq(q_vector, ring,
+ per_ring_budget);
+ work_done += cleaned;
+ clean_complete &= (cleaned < per_ring_budget);
+ }
#ifdef CONFIG_NET_RX_BUSY_POLL
ixgbevf_qv_unlock_napi(q_vector);
if (!clean_complete)
return budget;
/* all work done, exit the polling mode */
- napi_complete(napi);
+ napi_complete_done(napi, work_done);
if (adapter->rx_itr_setting & 1)
ixgbevf_set_itr(q_vector);
if (!test_bit(__IXGBEVF_DOWN, &adapter->state) &&