Please pass on any feedback on any of this stuff to the maintainer,
whose address can be found in linux/MAINTAINERS.
-Note that if BOTH hd.c and ide.c are configured into the kernel,
-hd.c will normally be allowed to control the primary IDE interface.
-This is useful for older hardware that may be incompatible with ide.c,
-and still allows newer hardware to run on the 2nd/3rd/4th IDE ports
-under control of ide.c. To have ide.c also "take over" the primary
-IDE port in this situation, use the "command line" parameter: ide0=0x1f0
-
The IDE driver is modularized. The high level disk/CD-ROM/tape/floppy
drivers can always be compiled as loadable modules, the chipset drivers
can only be compiled into the kernel, and the core code (ide.c) can be
If unsure, say N.
-config BLK_DEV_HD_IDE
- bool "Use old disk-only driver on primary interface"
- depends on (X86 || SH_MPC1211)
- ---help---
- There are two drivers for MFM/RLL/IDE disks. Most people use just
- the new enhanced driver by itself. This option however installs the
- old hard disk driver to control the primary IDE/disk interface in
- the system, leaving the new enhanced IDE driver to take care of only
- the 2nd/3rd/4th IDE interfaces. Doing this will prevent you from
- having an IDE/ATAPI CD-ROM or tape drive connected to the primary
- IDE interface. Choosing this option may be useful for older systems
- which have MFM/RLL/ESDI controller+drives at the primary port
- address (0x1f0), along with IDE drives at the secondary/3rd/4th port
- addresses.
-
- Normally, just say N here; you will then use the new driver for all
- 4 interfaces.
-
config BLK_DEV_IDEDISK
tristate "Include IDE/ATA-2 DISK support"
---help---
config BLK_DEV_HD_ONLY
bool "Old hard disk (MFM/RLL/IDE) driver"
- depends on BLK_DEV_IDE=n
help
There are two drivers for MFM/RLL/IDE hard disks. Most people use
the newer enhanced driver, but this old one is still around for two
for systems with only older MFM/RLL/ESDI drives. Choosing the old
driver can save 13 KB or so of kernel memory.
+ If you want to use this driver together with the new one you have
+ to use "hda=noprobe hdb=noprobe" kernel parameters to prevent the new
+ driver from probing the primary interface.
+
If you are unsure, then just choose the Enhanced IDE/MFM/RLL driver
instead of this one. For more detailed information, read the
Disk-HOWTO, available from
<http://www.tldp.org/docs.html#howto>.
config BLK_DEV_HD
- def_bool BLK_DEV_HD_IDE || BLK_DEV_HD_ONLY
+ def_bool BLK_DEV_HD_ONLY
endif # IDE
memcpy(hwif->io_ports, hw.io_ports, sizeof(hw.io_ports));
hwif->noprobe = !hwif->io_ports[IDE_DATA_OFFSET];
-#ifdef CONFIG_BLK_DEV_HD
- if (hwif->io_ports[IDE_DATA_OFFSET] == HD_DATA)
- hwif->noprobe = 1; /* may be overridden by ide_setup() */
-#endif
}
/*