arm64: dts: qcom: pmi8994: add interrupt controller properties

Add interrupt controller properties now that spmi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.

This change was not tested on any hardware but the same change was
tested on qcom-pm8941.dtsi using a LG Nexus 5 (hammerhead) phone with
no issues.

Signed-off-by: Brian Masney <masneyb@onstation.org>
Reviewed-by: Stephen Boyd <sboyd@kernel.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

diff --git a/arch/arm64/boot/dts/qcom/pmi8994.dtsi b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
index dae1cdc23f5433ba4bb3f7d14a937e491e491a61..3aee10e3f92110cbfb18ea9401bbe3e62d4a2d7b 100644 (file)
--- a/arch/arm64/boot/dts/qcom/pmi8994.dtsi
+++ b/arch/arm64/boot/dts/qcom/pmi8994.dtsi
@@ -15,16 +15,8 @@
                        reg = <0xc000>;
                        gpio-controller;
                        #gpio-cells = <2>;
-                       interrupts = <2 0xc0 0 IRQ_TYPE_NONE>,
-                                    <2 0xc1 0 IRQ_TYPE_NONE>,
-                                    <2 0xc2 0 IRQ_TYPE_NONE>,
-                                    <2 0xc3 0 IRQ_TYPE_NONE>,
-                                    <2 0xc4 0 IRQ_TYPE_NONE>,
-                                    <2 0xc5 0 IRQ_TYPE_NONE>,
-                                    <2 0xc6 0 IRQ_TYPE_NONE>,
-                                    <2 0xc7 0 IRQ_TYPE_NONE>,
-                                    <2 0xc8 0 IRQ_TYPE_NONE>,
-                                    <2 0xc9 0 IRQ_TYPE_NONE>;
+                       interrupt-controller;
+                       #interrupt-cells = <2>;
                };
        };