ARM: dts: imx7s-warp: enable uart6 on mikroBus

This patch configures the board to output UART6 to the mikroBus.

The NXP WaRP7 board can route UART6 to the mikroBus, where an RS232
click board can be plugged in to get an additional serial port.

Signed-off-by: Ryan Harkin <ryan.harkin@linaro.org>
Reviewed-by: Rui Miguel Silva <rui.silva@linaro.org>
Reviewed-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

diff --git a/arch/arm/boot/dts/imx7s-warp.dts b/arch/arm/boot/dts/imx7s-warp.dts
index 9bdf121f7e4358840c969b859d683ed25f321529..1606713bf66c1d4157c3ef444c242409ab3c27ab 100644 (file)
--- a/arch/arm/boot/dts/imx7s-warp.dts
+++ b/arch/arm/boot/dts/imx7s-warp.dts
@@ -271,6 +271,15 @@
        status = "okay";
 };
 
+&uart6 {
+       pinctrl-names = "default";
+       pinctrl-0 = <&pinctrl_uart6>;
+       assigned-clocks = <&clks IMX7D_UART6_ROOT_SRC>;
+       assigned-clock-parents = <&clks IMX7D_PLL_SYS_MAIN_240M_CLK>;
+       fsl,dte-mode;
+       status = "okay";
+};
+
 &usbotg1 {
        dr_mode = "peripheral";
        status = "okay";
@@ -379,6 +388,13 @@
                >;
        };
 
+       pinctrl_uart6: uart6grp {
+               fsl,pins = <
+                       MX7D_PAD_ECSPI1_MOSI__UART6_DTE_RX      0x79
+                       MX7D_PAD_ECSPI1_SCLK__UART6_DTE_TX      0x79
+               >;
+       };
+
        pinctrl_usdhc1: usdhc1grp {
                fsl,pins = <
                        MX7D_PAD_SD1_CMD__SD1_CMD       0x59