ath10k: fill in wmi 10.4 command handlers for addba/delba debug commands

WMI 10.4 uses the same command interface as QCA988X for addba/delba
debug wmi commands. Fill wmi_10_4_ops table with the functions used
for QCA988X for these commands.

With this change, the following debugfs entries can be used to
configure the aggregation mode and to send addba request,
addba response and delba respectively in manual aggregation mode
for QCA99X0 chip.

/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/aggr_mode
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/addba_resp
/sys/kernel/debug/ieee80211/phyX/netdev:wlanX/stations/XX:XX:XX:XX:XX:XX/delba

Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

diff --git a/drivers/net/wireless/ath/ath10k/wmi.c b/drivers/net/wireless/ath/ath10k/wmi.c
index 61af11a07b97712cc6c609a09d6870a67858fa97..42c0aba04fb2409bc192af5f292a1d85f2607ec2 100644 (file)
--- a/drivers/net/wireless/ath/ath10k/wmi.c
+++ b/drivers/net/wireless/ath/ath10k/wmi.c
@@ -6597,6 +6597,10 @@ static const struct wmi_ops wmi_10_4_ops = {
        .gen_pktlog_enable = ath10k_wmi_op_gen_pktlog_enable,
        .gen_pktlog_disable = ath10k_wmi_op_gen_pktlog_disable,
        .gen_pdev_set_quiet_mode = ath10k_wmi_op_gen_pdev_set_quiet_mode,
+       .gen_addba_clear_resp = ath10k_wmi_op_gen_addba_clear_resp,
+       .gen_addba_send = ath10k_wmi_op_gen_addba_send,
+       .gen_addba_set_resp = ath10k_wmi_op_gen_addba_set_resp,
+       .gen_delba_send = ath10k_wmi_op_gen_delba_send,
 
        /* shared with 10.2 */
        .gen_peer_assoc = ath10k_wmi_10_2_op_gen_peer_assoc,