"Asynchronous" is misspelled in some comments. No code changes.
Signed-off-by: Adam Buchbinder <adam.buchbinder@gmail.com>
Signed-off-by: Jiri Kosina <jkosina@suse.cz>
} else if ((msg->rsp[0] == ((IPMI_NETFN_APP_REQUEST|1) << 2))
&& (msg->rsp[1] == IPMI_READ_EVENT_MSG_BUFFER_CMD)) {
- /* It's an asyncronous event. */
+ /* It's an asynchronous event. */
requeue = handle_read_event_rsp(intf, msg);
} else {
/* It's a response from the local BMC. */
/* Number of watchdog pretimeouts. */
SI_STAT_watchdog_pretimeouts,
- /* Number of asyncronous messages received. */
+ /* Number of asynchronous messages received. */
SI_STAT_incoming_messages,
reg_write(ohci, OHCI1394_IsoXmitIntMaskClear, 0xffffffff);
reg_write(ohci, OHCI1394_IsoXmitIntEventClear, 0xffffffff);
- /* Accept asyncronous transfer requests from all nodes for now */
+ /* Accept asynchronous transfer requests from all nodes for now */
reg_write(ohci, OHCI1394_AsReqFilterHiSet, 0x80000000);
- /* Specify asyncronous transfer retries */
+ /* Specify asynchronous transfer retries */
reg_write(ohci, OHCI1394_ATRetries,
OHCI1394_MAX_AT_REQ_RETRIES |
(OHCI1394_MAX_AT_RESP_RETRIES<<4) |
d[0].res_count = cpu_to_le16(packet->timestamp);
/*
- * The DMA format for asyncronous link packets is different
+ * The DMA format for asynchronous link packets is different
* from the IEEE1394 layout, so shift the fields around
* accordingly.
*/
/* Temporary use polling for command completions */
mlx4_cmd_use_polling(dev);
- /* Map the new eq to handle all asyncronous events */
+ /* Map the new eq to handle all asynchronous events */
err = mlx4_MAP_EQ(dev, get_async_ev_mask(dev), 0,
priv->eq_table.eq[i].eqn);
if (err) {
unsigned char sig_no; /* TL_SETUP_SIGNO_CONFIG_DONE_MSG */
} __attribute__ ((__packed__));
-/* Asyncronous messages */
+/* Asynchronous messages */
struct tl_setup_open_msg {
unsigned char sig_no; /* TL_SETUP_SIGNO_OPEN_MSG */
unsigned char port_no;
/*
* Basic idea behind the notification queue: An fsnotify group (like inotify)
- * sends the userspace notification about events asyncronously some time after
+ * sends the userspace notification about events asynchronously some time after
* the event happened. When inotify gets an event it will need to add that
* event to the group notify queue. Since a single event might need to be on
* multiple group's notification queues we can't add the event directly to each
/*
* dlm_lock
*
- * Make an asyncronous request to acquire or convert a lock on a named
+ * Make an asynchronous request to acquire or convert a lock on a named
* resource.
*
* lockspace: context for the request
/*
* The lower layer reports received messages through this interface.
- * The data_size should be zero if this is an asyncronous message. If
+ * The data_size should be zero if this is an asynchronous message. If
* the lower layer gets an error sending a message, it should format
* an error response in the message response.
*/
goto repeat;
}
}
- /* drain all zone's lru pagevec, this is asyncronous... */
+ /* drain all zone's lru pagevec, this is asynchronous... */
lru_add_drain_all();
yield();
- /* drain pcp pages , this is synchrouns. */
+ /* drain pcp pages, this is synchronous. */
drain_all_pages();
/* check again */
offlined_pages = check_pages_isolated(start_pfn, end_pfn);
goto failed_removal;
}
printk(KERN_INFO "Offlined Pages %ld\n", offlined_pages);
- /* Ok, all of our target is islaoted.
+ /* Ok, all of our target is isolated.
We cannot do rollback at this point. */
offline_isolated_pages(start_pfn, end_pfn);
/* reset pagetype flags and makes migrate type to be MOVABLE */
outl(SIS_DMA_CSR_PCI_SETTINGS, io + SIS_DMA_CSR);
/* Reset the synchronization groups for all of the channels
- * to be asyncronous. If we start doing SPDIF or 5.1 sound, etc.
+ * to be asynchronous. If we start doing SPDIF or 5.1 sound, etc.
* we'll need to change how we handle these. Until then, we just
* assign sub-mixer 0 to all playback channels, and avoid any
* attenuation on the audio.