#define DRIVER_NAME "mmci-pl18x"
-#ifdef CONFIG_DMA_ENGINE
static void mmci_variant_init(struct mmci_host *host);
-#else
-static inline void mmci_variant_init(struct mmci_host *host) {}
-#endif
+static void ux500v2_variant_init(struct mmci_host *host);
static unsigned int fmax = 515633;
.irq_pio_mask = MCI_IRQ_PIO_MASK,
.start_err = MCI_STARTBITERR,
.opendrain = MCI_OD,
- .init = mmci_variant_init,
+ .init = ux500v2_variant_init,
};
static struct variant_data variant_stm32 = {
sg_miter_start(&host->sg_miter, data->sg, data->sg_len, flags);
}
+static u32 mmci_get_dctrl_cfg(struct mmci_host *host)
+{
+ return MCI_DPSM_ENABLE | mmci_dctrl_blksz(host);
+}
+
+static u32 ux500v2_get_dctrl_cfg(struct mmci_host *host)
+{
+ return MCI_DPSM_ENABLE | (host->data->blksz << 16);
+}
+
/*
* All the DMA operation mode stuff goes inside this ifdef.
* This assumes that you have a generic DMA device interface,
static struct mmci_host_ops mmci_variant_ops = {
.prep_data = mmci_dmae_prep_data,
.unprep_data = mmci_dmae_unprep_data,
+ .get_datactrl_cfg = mmci_get_dctrl_cfg,
.get_next_data = mmci_dmae_get_next_data,
.dma_setup = mmci_dmae_setup,
.dma_release = mmci_dmae_release,
.dma_finalize = mmci_dmae_finalize,
.dma_error = mmci_dmae_error,
};
+#else
+static struct mmci_host_ops mmci_variant_ops = {
+ .get_datactrl_cfg = mmci_get_dctrl_cfg,
+};
+#endif
void mmci_variant_init(struct mmci_host *host)
{
host->ops = &mmci_variant_ops;
}
-#endif
+
+void ux500v2_variant_init(struct mmci_host *host)
+{
+ host->ops = &mmci_variant_ops;
+ host->ops->get_datactrl_cfg = ux500v2_get_dctrl_cfg;
+}
static void mmci_pre_request(struct mmc_host *mmc, struct mmc_request *mrq)
{