ath79: ubnt-bullet-m-xw: fix Ethernet PHY traffic

Since commit 6f2e1b7485f0 ("ath79: disable delays on AT803X config init")
Ubiquiti XW boards equipped with AR8035 PHY suffered from lack of
outbound traffic on the Ethernet port. This was caused by the fact, the
U-boot has set this during boot and it wasn't reset by the PHY driver,
and the corresponding setting in device tree was wrong.

Set the 'phy-mode = "rgmii-txid"' at the &eth0, and drop this property
from PHY node, as it is not parsed there. This causes the device to
connect using Ethernet once again.

Fixes: db4b6535f837 ("ath79: Add support for Ubiquity Bullet M (XW)")
Fixes: 6f2e1b7485f0 ("ath79: disable delays on AT803X config init")
Signed-off-by: Lech Perczak <lech.perczak@gmail.com>
(cherry picked from commit a9b2ba4d7ba06e1ac4ff7da3eb9b4038b94d9fbb)

diff --git a/target/linux/ath79/dts/ar9342_ubnt_bullet-m-xw.dts b/target/linux/ath79/dts/ar9342_ubnt_bullet-m-xw.dts
index 73cc9779859f59f6edfcfaa0738e3788680c8e4b..97d787abba525e2d54c7054b2cc4ca59d3930339 100644 (file)
--- a/target/linux/ath79/dts/ar9342_ubnt_bullet-m-xw.dts
+++ b/target/linux/ath79/dts/ar9342_ubnt_bullet-m-xw.dts
@@ -12,7 +12,6 @@
 
        phy-mask = <4>;
        phy4: ethernet-phy@4 {
-               phy-mode = "rgmii";
                reg = <4>;
                max-speed = <100>;
        };
@@ -21,7 +20,7 @@
 &eth0 {
        status = "okay";
 
-       phy-mode = "rgmii";
+       phy-mode = "rgmii-txid";
        phy-handle = <&phy4>;
 
        gmac-config {