From: David Bauer Date: Thu, 19 Mar 2020 09:33:20 +0000 (+0100) Subject: ath79: align Ubiquiti AC Pro ethernet map to factory X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=280868e54d52c6d9bca987dc476dd0adac2922ab;p=openwrt%2Fstaging%2Fjow.git ath79: align Ubiquiti AC Pro ethernet map to factory The Uniquiti AC Pro and Ubiquiti AC Mesh Pro currently have the "Primary" and "Secondary" ethernet ports configured to offer LAN as well as WAN. However, Uiquiti describes the following behavior for the devices Ethernet ports: > Secondary UniFi Access Point (UAP) Ethernet ports don't > provide PoE passthrough (to run current to a second powered > device), but they do support data passthrough. > It serves as a bridged interface between main / secondary > Ethernet port. To reduce confusion for users (as LAN and WAN functionality is not visible on the device itself), configure both ports to offer LAN functionality. Users can still configure a WAN interface on a port they are able to choose. CC: Lucian Cristian Reported-by: Florian Klink Signed-off-by: David Bauer --- diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index cb84d31c01..9db21caad8 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -185,8 +185,6 @@ ath79_setup_interfaces() ;; nec,wg1200cr|\ ubnt,nanostation-ac|\ - ubnt,unifiac-mesh-pro|\ - ubnt,unifiac-pro|\ yuncore,a782|\ yuncore,xd4200) ucidef_add_switch "switch0" \ @@ -307,6 +305,11 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth0" "5:lan" "1:wan" ;; + ubnt,unifiac-mesh-pro|\ + ubnt,unifiac-pro) + ucidef_add_switch "switch0" \ + "0@eth0" "2:lan:1" "3:lan:2" + ;; zbtlink,zbt-wd323|\ xiaomi,mi-router-4q) ucidef_set_interface_wan "eth1"