From: Lucian Cristian Date: Wed, 20 Jun 2018 22:02:10 +0000 (+0300) Subject: ath79: add tl-wr2543-v1 support X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=2a7e03af37d1112c2c2f6b6c80283d4d49407889;p=openwrt%2Fstaging%2Fblocktrron.git ath79: add tl-wr2543-v1 support to switch between wlan leds we need a userspace implementation Signed-off-by: Lucian Cristian --- diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 743b877aba..d978c3441e 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -70,6 +70,10 @@ ath79_setup_interfaces() ucidef_add_switch "switch0" \ "0@eth1" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "5:wan" "6@eth0" ;; + "tplink,tl-wr2543-v1") + ucidef_add_switch "switch0" \ + "1:lan" "2:lan" "3:lan" "4:lan" "0:wan" "9@eth0" + ;; "netgear,wndr3800") ucidef_set_interfaces_lan_wan "eth0" "eth1" ucidef_add_switch "switch0" \ diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index 5b22b1544f..7023fa5e58 100644 --- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -57,6 +57,7 @@ case "$FIRMWARE" in "netgear,wnr612-v2"|\ "on,n150r"|\ "tplink,tl-wr740n-v2"|\ + "tplink,tl-wr2543-v1"|\ "ubnt,unifi") ath9k_eeprom_extract "art" 4096 2048 ;; diff --git a/target/linux/ath79/config-4.14 b/target/linux/ath79/config-4.14 index 0e24582cc7..01d259572a 100644 --- a/target/linux/ath79/config-4.14 +++ b/target/linux/ath79/config-4.14 @@ -205,6 +205,7 @@ CONFIG_RESET_CONTROLLER=y CONFIG_RTL8366RB_PHY=y CONFIG_RTL8366S_PHY=y CONFIG_RTL8366_SMI=y +CONFIG_RTL8367_PHY=y # CONFIG_SCHED_INFO is not set # CONFIG_SCSI_DMA is not set # CONFIG_SERIAL_8250_FSL is not set diff --git a/target/linux/ath79/dts/ar7242_tl-wr2543-v1.dts b/target/linux/ath79/dts/ar7242_tl-wr2543-v1.dts new file mode 100644 index 0000000000..0934fe0089 --- /dev/null +++ b/target/linux/ath79/dts/ar7242_tl-wr2543-v1.dts @@ -0,0 +1,186 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "ar7242.dtsi" + +/ { + compatible = "tplink,tl-wr2543-v1", "qca,ar7242"; + model = "TP-LINK TL-WR2543N/ND"; + + aliases { + led-status = &system; + }; + + chosen { + bootargs = "console=ttyS0,115200n8"; + }; + + memory@0 { + device_type = "memory"; + reg = <0x0 0x4000000>; + }; + + extosc: ref { + compatible = "fixed-clock"; + #clock-cells = <0>; + clock-frequency = <40000000>; + }; + + gpio-keys { + compatible = "gpio-keys-polled"; + #address-cells = <1>; + #size-cells = <0>; + poll-interval = <20>; + + reset { + label = "reset"; + linux,code = ; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + + wps { + label = "wps"; + linux,code = ; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; + + leds { + compatible = "gpio-leds"; + + system: wps { + label = "tplink:green:wps"; + gpios = <&gpio 0 GPIO_ACTIVE_LOW>; + default-state = "off"; + }; + + usb { + label = "tplink:green:usb"; + gpios = <&gpio 8 GPIO_ACTIVE_LOW>; + default-state = "off"; + trigger-sources = <&hub_port>; + linux,default-trigger = "usbport"; + }; + }; + + ath9k-leds { + compatible = "gpio-leds"; + + wlan2g { + label = "tplink:green:wlan2g"; + gpios = <&ath9k 0 GPIO_ACTIVE_LOW>; + default-state = "off"; + linux,default-trigger = "phy0tpt"; + }; + + wlan5g { + label = "tplink:green:wlan5g"; + gpios = <&ath9k 1 GPIO_ACTIVE_LOW>; + default-state = "off"; + linux,default-trigger = "phy0tpt"; + }; + + }; + + rtl8367 { + compatible = "realtek,rtl8367"; + gpio-sda = <&gpio 1 GPIO_ACTIVE_HIGH>; + gpio-sck = <&gpio 6 GPIO_ACTIVE_HIGH>; + realtek,extif0 = <1 0 1 1 1 1 1 1 2>; + + mdio-bus { + status = "okay"; + + phy0: ethernet-phy@0 { + reg = <0>; + }; + }; + }; +}; + +&pll { + clocks = <&extosc>; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + #address-cells = <1>; + #size-cells = <1>; + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + uboot: partition@0 { + label = "u-boot"; + reg = <0x000000 0x020000>; + read-only; + }; + + partition@20000 { + label = "firmware"; + reg = <0x020000 0x7d0000>; + }; + + partition@7f0000 { + label = "art"; + reg = <0x7f0000 0x010000>; + read-only; + }; + }; + }; +}; + +&uart { + status = "okay"; +}; + +&usb { + status = "okay"; + + hub_port: port@1 { + reg = <1>; + #trigger-source-cells = <0>; + }; +}; + +&usb_phy { + status = "okay"; +}; + +&pcie { + status = "okay"; + + ath9k: wifi@0 { + reg = <0x0000 0 0 0 0>; + #gpio-cells = <2>; + gpio-controller; + qca,no-eeprom; + mtd-mac-address = <&uboot 0x1fc00>; + }; +}; + +ð0 { + status = "okay"; + + phy-mode = "rgmii"; + mtd-mac-address = <&uboot 0x1fc00>; + + phy-handle = <&phy0>; + fixed-link { + speed = <1000>; + full-duplex; + }; +}; diff --git a/target/linux/ath79/image/generic-tp-link.mk b/target/linux/ath79/image/generic-tp-link.mk index 467e2c4c42..accaf3b68f 100644 --- a/target/linux/ath79/image/generic-tp-link.mk +++ b/target/linux/ath79/image/generic-tp-link.mk @@ -62,3 +62,16 @@ define Device/tl-wr1043nd-v4 SUPPORTED_DEVICES := tplink,tl-wr1043nd-v4 tl-wr1043nd-v4 endef TARGET_DEVICES += tl-wr1043nd-v4 + +define Device/tl-wr2543-v1 + $(Device/tplink-8mlzma) + ATH_SOC := ar7242 + DEVICE_TITLE := TP-LINK TL-WR2543N/ND v1 + DEVICE_PACKAGES := kmod-usb-core kmod-usb2 kmod-usb-ledtrig-usbport + TPLINK_HWID := 0x25430001 + IMAGE/sysupgrade.bin := append-rootfs | mktplinkfw sysupgrade -v 3.13.99 | \ + append-metadata | check-size $$$$(IMAGE_SIZE) + IMAGE/factory.bin := append-rootfs | mktplinkfw factory -v 3.13.99 + SUPPORTED_DEVICES := tplink,tl-wr2543-v1 tl-wr2543-v1 +endef +TARGET_DEVICES += tl-wr2543-v1