From: Gabriel Krisman Bertazi Date: Fri, 30 Oct 2015 18:04:43 +0000 (-0200) Subject: sd: Clear PS bit before Mode Select. X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=2c5d16d6a9e7218e57b716e4fd9d77c776d21471;p=openwrt%2Fstaging%2Fblogic.git sd: Clear PS bit before Mode Select. According to SPC-4, in a Mode Select, the PS bit in Mode Pages is reserved and must be set to 0 by the driver. In the sd implementation, function cache_type_store does a Mode Sense, which might set the PS bit on the read buffer, followed by a Mode Select, which receives the same buffer, without explicitly clearing the PS bit. So, in cases where target supports saving the Mode Page to a non-volatile location, we end up doing a Mode Select with the PS bit set, which could cause an illegal request error if the target is checking this. This was observed on a new firmware change, which was subsequently reverted, but this changes sd.c to be more compliant with SPC-4. This patch clears the PS bit in the buffer returned by Mode Select, right before it is used in the Mode Select command. Signed-off-by: Gabriel Krisman Bertazi Signed-off-by: Martin K. Petersen --- diff --git a/drivers/scsi/sd.c b/drivers/scsi/sd.c index 3f370228bf31..f7247778c225 100644 --- a/drivers/scsi/sd.c +++ b/drivers/scsi/sd.c @@ -204,6 +204,7 @@ cache_type_store(struct device *dev, struct device_attribute *attr, buffer_data[2] &= ~0x05; buffer_data[2] |= wce << 2 | rcd; sp = buffer_data[0] & 0x80 ? 1 : 0; + buffer_data[0] &= ~0x80; if (scsi_mode_select(sdp, 1, sp, 8, buffer_data, len, SD_TIMEOUT, SD_MAX_RETRIES, &data, &sshdr)) {