From: Sascha Hauer Date: Fri, 17 Nov 2017 11:09:12 +0000 (+0100) Subject: mtd: nand: gpmi-nand: Remove wrong Kconfig help text X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=34832dc44d44d7ea586617d99895e8cfc840be03;p=openwrt%2Fstaging%2Fblogic.git mtd: nand: gpmi-nand: Remove wrong Kconfig help text The GPMI nand Kconfig help texts mentions that the GPMI nand driver might conflict with SD cards. The only conflict there might really be is that both controllers use the same pins, but this is resolved by the pincontroller setup in the device tree. In any way the GPMI driver can safely be enabled, the text is just wrong. Remove it. Signed-off-by: Sascha Hauer Reviewed-by: Fabio Estevam Acked-by: Han Xu Signed-off-by: Boris Brezillon --- diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig index bb48aafed9a2..859eb7790c46 100644 --- a/drivers/mtd/nand/Kconfig +++ b/drivers/mtd/nand/Kconfig @@ -376,9 +376,7 @@ config MTD_NAND_GPMI_NAND Enables NAND Flash support for IMX23, IMX28 or IMX6. The GPMI controller is very powerful, with the help of BCH module, it can do the hardware ECC. The GPMI supports several - NAND flashs at the same time. The GPMI may conflicts with other - block, such as SD card. So pay attention to it when you enable - the GPMI. + NAND flashs at the same time. config MTD_NAND_BRCMNAND tristate "Broadcom STB NAND controller"