From: Dongming Han Date: Thu, 7 Dec 2017 12:48:19 +0000 (+0800) Subject: ipq806x: add support for GL.iNet GL-B1300 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=395f0129f86a0995ba65e1768a8ed5fdcec3148e;p=project%2Ffirmware%2Fqca-wireless.git ipq806x: add support for GL.iNet GL-B1300 This patch adds support for GL.iNet GL-B1300 Specification: - SOC: IPQ4028 / QCA Dakota - RAM: 256 MiB - FLASH: 32 MiB - ETH: Qualcomm Atheros QCA8075 Gigabit Switch (2 x LAN, 1 x WAN) - USB: 1 x 3.0 (via Synopsys DesignWare DWC3 controller in the SoC) - WLAN1: Qualcomm Atheros QCA4028 2.4GHz 802.11bgn 2:2x2 - WLAN2: Qualcomm Atheros QCA4028 5GHz 802.11a/n/ac 2:2x2 - INPUT: one reset and one WPS button - LEDS: 3 leds: Power, WIFI(only for 2.4G currently), and one reserved - UART: 1 x UART on PCB (3.3V, TX, RX, GND) - 115200 8N1 Installation: Method 1: - use serial port to stop uboot - uboot command: run lf Method 2: - push down reset button and power on - wait until three leds constantly on then release - upgrade by uboot web at http://192.168.1.1 Note: - the sysupgrade image need to be renamed to lede-gl-b1300.bin in both method. - the sysupgrade image can be automatically downloaded if tftp server at 192.168.1.2 have that file. - the wifi led will be flashing when writing image. Signed-off-by: Dongming Han --- diff --git a/board-glinet_gl-b1300.bin b/board-glinet_gl-b1300.bin new file mode 100644 index 0000000..f2020f6 Binary files /dev/null and b/board-glinet_gl-b1300.bin differ