From: Hans de Goede <hdegoede@redhat.com>
Date: Fri, 7 Aug 2015 15:22:35 +0000 (+0200)
Subject: ARM: dts: sun6i: Columbus: Add i2c controller for communicating with the LCD
X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=465274d73c7b17578cf1f2444c50086bb2697c2c;p=openwrt%2Fstaging%2Fblogic.git

ARM: dts: sun6i: Columbus: Add i2c controller for communicating with the LCD

The Colombus development kit uses an optional 2048x1536 edp panel using
an anx9804 parallel lcd to edp converter. The anx9804 chip is controlled
via an i2c bus which is connected to 2 regular gpio pins.

Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Signed-off-by: Maxime Ripard <maxime.ripard@free-electrons.com>
---

diff --git a/arch/arm/boot/dts/sun6i-a31-colombus.dts b/arch/arm/boot/dts/sun6i-a31-colombus.dts
index 0cf9926d1e93..8843420a4cba 100644
--- a/arch/arm/boot/dts/sun6i-a31-colombus.dts
+++ b/arch/arm/boot/dts/sun6i-a31-colombus.dts
@@ -60,6 +60,16 @@
 	chosen {
 		stdout-path = "serial0:115200n8";
 	};
+
+	i2c_lcd: i2c@0 {
+		/* The lcd panel i2c interface is hooked up via gpios */
+		compatible = "i2c-gpio";
+		pinctrl-names = "default";
+		pinctrl-0 = <&i2c_lcd_pins>;
+		gpios = <&pio 0 23 GPIO_ACTIVE_HIGH>, /* PA23, sda */
+			<&pio 0 24 GPIO_ACTIVE_HIGH>; /* PA24, scl */
+		i2c-gpio,delay-us = <5>;
+	};
 };
 
 &ehci1 {
@@ -112,6 +122,13 @@
 		allwinner,drive = <SUN4I_PINCTRL_10_MA>;
 		allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
 	};
+
+	i2c_lcd_pins: i2c_lcd_pin@0 {
+		allwinner,pins = "PA23", "PA24";
+		allwinner,function = "gpio_out";
+		allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+		allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
+	};
 };
 
 &reg_usb2_vbus {