From: INAGAKI Hiroshi Date: Thu, 14 Mar 2019 14:46:43 +0000 (+0900) Subject: ramips: add support for I-O DATA WN-AC733GR3 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=5c112582974218fd4e4624b36dbdeb8edeff55b7;p=openwrt%2Fstaging%2Fthess.git ramips: add support for I-O DATA WN-AC733GR3 I-O DATA WN-AC733GR3 is a 2.4/5 GHz band 11ac router, based on MediaTek MT7620A. Specification - SoC : MediaTek MT7620A - RAM : DDR2 64 MiB - Flash : SPI-NOR 8 MiB - WLAN : 2.4/5 GHz - 2.4 GHz : MT7620A (SoC), 2T2R - 5 GHz : MT7610E, 1T1R - Ethernet : 10/100/1000 Mbps (RTL8367RB) - LED/key : 4x/4x (2x buttons, 1x slide-switch) - UART : through-hole on PCB - J1: Vcc, RX, GND, TX from LED side - 57600n8 Flash instruction using factory image: 1. Boot WN-AC733GR3 normaly 2. Access to "http://192.168.0.1/" and open firmware update page ("ファームウェア") 3. Select the OpenWrt factory image and click update ("更新") button to perform firmware update 4. Wait ~150 seconds to complete flashing Signed-off-by: INAGAKI Hiroshi --- diff --git a/target/linux/ramips/base-files/etc/board.d/01_leds b/target/linux/ramips/base-files/etc/board.d/01_leds index 9cca231ab6..69b95ee540 100755 --- a/target/linux/ramips/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/base-files/etc/board.d/01_leds @@ -196,7 +196,8 @@ ht-tm02) ucidef_set_led_netdev "eth" "Ethernet" "$boardname:green:lan" "eth0" set_wifi_led "$boardname:blue:wlan" ;; -iodata,wn-ac1167gr) +iodata,wn-ac1167gr|\ +iodata,wn-ac733gr3) ucidef_set_led_wlan "wlan5g" "WLAN5G" "$boardname:green:wlan5g" "phy0radio" ucidef_set_led_wlan "wlan2g" "WLAN2G" "$boardname:green:wlan2g" "phy1radio" ;; diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index 890efa0d93..20a50cc6de 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -324,7 +324,8 @@ ramips_setup_interfaces() ucidef_add_switch "switch0" \ "0:lan" "1:lan" "5:wan" "6@eth0" ;; - iodata,wn-ac1167gr) + iodata,wn-ac1167gr|\ + iodata,wn-ac733gr3) ucidef_add_switch "switch1" \ "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "0:wan" "6@eth0" ;; @@ -546,7 +547,8 @@ ramips_setup_macs() [ -n "$lan_mac" ] || lan_mac=$(cat /sys/class/net/eth0/address) wan_mac=$(macaddr_add "$lan_mac" 1) ;; - iodata,wn-ac1167gr) + iodata,wn-ac1167gr|\ + iodata,wn-ac733gr3) wan_mac=$(macaddr_add "$(mtd_get_mac_binary Factory 4)" -1) ;; iodata,wn-ax1167gr|\ diff --git a/target/linux/ramips/dts/WN-AC733GR3.dts b/target/linux/ramips/dts/WN-AC733GR3.dts new file mode 100644 index 0000000000..ea837c4d34 --- /dev/null +++ b/target/linux/ramips/dts/WN-AC733GR3.dts @@ -0,0 +1,198 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include "mt7620a.dtsi" + +#include +#include + +/ { + compatible = "iodata,wn-ac733gr3", "ralink,mt7620a-soc"; + model = "I-O DATA WN-AC733GR3"; + + aliases { + led-boot = &led_power; + led-failsafe = &led_power; + led-running = &led_power; + led-upgrade = &led_power; + }; + + memory@0 { + device_type = "memory"; + reg = <0x0 0x4000000>; + }; + + leds { + compatible = "gpio-leds"; + + led_power: power { + label = "wn-ac733gr3:green:power"; + gpios = <&gpio0 7 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + notification { + label = "wn-ac733gr3:green:notification"; + gpios = <&gpio0 8 GPIO_ACTIVE_LOW>; + }; + + wlan2g { + label = "wn-ac733gr3:green:wlan2g"; + gpios = <&gpio0 10 GPIO_ACTIVE_LOW>; + }; + + wlan5g { + label = "wn-ac733gr3:green:wlan5g"; + gpios = <&gpio0 14 GPIO_ACTIVE_LOW>; + }; + }; + + keys { + compatible = "gpio-keys-polled"; + poll-interval = <20>; + + reset { + label = "reset"; + gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + + wps { + label = "wps"; + gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + + router { + label = "router"; + gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; + linux,code = ; + linux,input-type = ; + }; + + auto { + label = "auto"; + gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; + linux,code = ; + linux,input-type = ; + }; + }; + + rtl8367rb { + compatible = "realtek,rtl8367b"; + gpio-sda = <&gpio0 22 GPIO_ACTIVE_HIGH>; + gpio-sck = <&gpio0 23 GPIO_ACTIVE_HIGH>; + realtek,extif1 = <1 0 1 1 1 1 1 1 2>; + }; +}; + +&spi0 { + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <10000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0x30000>; + read-only; + }; + + partition@30000 { + label = "u-boot-env"; + reg = <0x30000 0x10000>; + read-only; + }; + + Factory: partition@40000 { + label = "Factory"; + reg = <0x40000 0x8000>; + read-only; + }; + + iNIC_rf: partition@48000 { + label = "iNIC_rf"; + reg = <0x48000 0x8000>; + read-only; + }; + + partition@50000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x50000 0x6d4000>; + }; + + partition@724000 { + label = "manufacture"; + reg = <0x724000 0x8c000>; + read-only; + }; + + partition@7b0000 { + label = "backup"; + reg = <0x7b0000 0x10000>; + read-only; + }; + + partition@7c0000 { + label = "storage"; + reg = <0x7c0000 0x40000>; + read-only; + }; + }; + }; +}; + +ðernet { + pinctrl-names = "default"; + pinctrl-0 = <&rgmii1_pins>; + mtd-mac-address = <&Factory 0x4>; + + port@5 { + status = "okay"; + mediatek,fixed-link = <1000 1 1 1>; + phy-mode = "rgmii"; + }; +}; + +&gpio0 { + rtl8367rb_reset { + gpio-hog; + gpios = <0 GPIO_ACTIVE_HIGH>; + output-high; + line-name = "rtl8367rb-reset"; + }; +}; + +&pinctrl { + state_default: pinctrl0 { + gpio { + ralink,group = "i2c", "uartf", "mdio"; + ralink,function = "gpio"; + }; + }; +}; + +&pcie { + status = "okay"; +}; + +&pcie0 { + wifi@0,0 { + compatible = "mediatek,mt76"; + reg = <0x0000 0 0 0 0>; + mediatek,mtd-eeprom = <&iNIC_rf 0x0>; + ieee80211-freq-limit = <5000000 6000000>; + }; +}; + +&wmac { + ralink,mtd-eeprom = <&Factory 0x0>; +}; diff --git a/target/linux/ramips/image/mt7620.mk b/target/linux/ramips/image/mt7620.mk index 77a5b5724d..0098613c27 100644 --- a/target/linux/ramips/image/mt7620.mk +++ b/target/linux/ramips/image/mt7620.mk @@ -367,6 +367,18 @@ define Device/iodata_wn-ac1167gr endef TARGET_DEVICES += iodata_wn-ac1167gr +define Device/iodata_wn-ac733gr3 + DTS := WN-AC733GR3 + DEVICE_TITLE := I-O DATA WN-AC733GR3 + IMAGE_SIZE := 6992k + IMAGES += factory.bin + IMAGE/factory.bin := \ + $$(sysupgrade_bin) | check-size $$$$(IMAGE_SIZE) | \ + elx-header 01040006 8844A2D168B45A2D + DEVICE_PACKAGES := kmod-mt76x0e kmod-switch-rtl8367b +endef +TARGET_DEVICES += iodata_wn-ac733gr3 + define Device/kimax_u35wf DTS := U35WF IMAGE_SIZE := 16064k