From: Alan Stern Date: Tue, 17 Apr 2012 19:23:25 +0000 (-0400) Subject: EHCI: don't try to clear the IAAD bit X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=6feff1b92bedab133c5835e510d11f62e843b257;p=openwrt%2Fstaging%2Fblogic.git EHCI: don't try to clear the IAAD bit This patch (as1541) corrects a small mistake in ehci-hcd. The IAAD (Interrupt on Async Advance Doorbell) bit in the USBCMD register is designed, as its name says, to act as a "doorbell". That is, the driver activates the bit by setting it to 1, and the hardware deactivates it later by setting it back to 0. The driver cannot clear the bit by writing a 0 to it; such writes are simply ignored. Therefore there is no reason for ehci-hcd to try to clear the bit. The patch removes the two instances where such attempts occur. Signed-off-by: Alan Stern Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c index 057cdda7a489..343f40c23b5f 100644 --- a/drivers/usb/host/ehci-hcd.c +++ b/drivers/usb/host/ehci-hcd.c @@ -415,9 +415,6 @@ static void ehci_iaa_watchdog(unsigned long param) * CMD_IAAD when it sets STS_IAA.) */ cmd = ehci_readl(ehci, &ehci->regs->command); - if (cmd & CMD_IAAD) - ehci_writel(ehci, cmd & ~CMD_IAAD, - &ehci->regs->command); /* If IAA is set here it either legitimately triggered * before we cleared IAAD above (but _way_ late, so we'll @@ -887,11 +884,8 @@ static irqreturn_t ehci_irq (struct usb_hcd *hcd) /* complete the unlinking of some qh [4.15.2.3] */ if (status & STS_IAA) { /* guard against (alleged) silicon errata */ - if (cmd & CMD_IAAD) { - ehci_writel(ehci, cmd & ~CMD_IAAD, - &ehci->regs->command); + if (cmd & CMD_IAAD) ehci_dbg(ehci, "IAA with IAAD still set?\n"); - } if (ehci->reclaim) { COUNT(ehci->stats.reclaim); end_unlink_async(ehci);