From: Sebastian Andrzej Siewior Date: Tue, 20 Aug 2013 16:35:49 +0000 (+0200) Subject: usb: musb: am335x-evm: Do not remove the session bit HOST-only mode X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=781f17983015dae33324e34d1bb831e715fa04d4;p=openwrt%2Fstaging%2Fblogic.git usb: musb: am335x-evm: Do not remove the session bit HOST-only mode This is what I observe: On the first connect, the musb starts with DEVCTL.Session set. On disconnect, musb_core calls try_idle. That functions removes the Session bit signalizing that the session is over (something that only in OTG is required). A new device, that is plugged, is no longer recognized. I've setup a timer and checked the DEVCTL register and I haven't seen a change in VBus and I saw the B-Device bit set. After setting the IDDIG into A mode and forcing the device to behave like a A device, I didn't see a change. Neither VBUS goes to 0b11 nor does a session start request comes. In the TI-v3.2 kernel they skip to call musb_platform_try_idle() in the OTG_STATE_A_WAIT_BCON state while not in OTG mode. Since the second port hast a standard A plug the patch changes the port to run in host mode only and skips the timer which would remove DEVCTL.Session so we can reconnect to another device later. Signed-off-by: Sebastian Andrzej Siewior Signed-off-by: Felipe Balbi --- diff --git a/arch/arm/boot/dts/am335x-evm.dts b/arch/arm/boot/dts/am335x-evm.dts index 648a67e74d1b..e8ec8756e498 100644 --- a/arch/arm/boot/dts/am335x-evm.dts +++ b/arch/arm/boot/dts/am335x-evm.dts @@ -192,6 +192,7 @@ usb@47401800 { status = "okay"; + dr_mode = "host"; }; dma-controller@07402000 { diff --git a/drivers/usb/musb/musb_dsps.c b/drivers/usb/musb/musb_dsps.c index 392406da3751..4047cbb91bac 100644 --- a/drivers/usb/musb/musb_dsps.c +++ b/drivers/usb/musb/musb_dsps.c @@ -231,6 +231,8 @@ static void dsps_musb_try_idle(struct musb *musb, unsigned long timeout) glue->last_timer = jiffies; return; } + if (musb->port_mode == MUSB_PORT_MODE_HOST) + return; if (time_after(glue->last_timer, timeout) && timer_pending(&glue->timer)) {