From: Adrian Schmutzler Date: Tue, 7 Jul 2020 09:49:36 +0000 (+0200) Subject: ramips: use WiFi LED DT triggers for TP-Link RE650 v1 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=7cb721c03fdc163818f8114692229d0097d2f26b;p=openwrt%2Fstaging%2Fadrian.git ramips: use WiFi LED DT triggers for TP-Link RE650 v1 This moves WiFi LED triggers from 01_leds to device tree. While at it, convert the labels there to lower case; this is more commonly used and the change will actually remove competition between DT trigger and leftover uci config on already installed systems. Suggested-by: Georgi Vlaev Signed-off-by: Adrian Schmutzler --- diff --git a/target/linux/ramips/dts/mt7621_tplink_re650-v1.dts b/target/linux/ramips/dts/mt7621_tplink_re650-v1.dts index ab8805f163..b7290635b9 100644 --- a/target/linux/ramips/dts/mt7621_tplink_re650-v1.dts +++ b/target/linux/ramips/dts/mt7621_tplink_re650-v1.dts @@ -23,13 +23,15 @@ }; wifi2g { - label = "re650-v1:blue:wifi2G"; + label = "re650-v1:blue:wifi2g"; gpios = <&gpio 23 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tpt"; }; wifi5g { - label = "re650-v1:blue:wifi5G"; + label = "re650-v1:blue:wifi5g"; gpios = <&gpio 24 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy1tpt"; }; wps_red { diff --git a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds index 2e3dca7901..37ebd0fb64 100755 --- a/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds +++ b/target/linux/ramips/mt7621/base-files/etc/board.d/01_leds @@ -68,14 +68,14 @@ netgear,r6800) ucidef_set_led_netdev "lan3" "LAN3" "$boardname:white:lan3" "lan3" ucidef_set_led_netdev "lan4" "LAN4" "$boardname:white:lan4" "lan4" ;; -tplink,re350-v1|\ -tplink,re650-v1) +tplink,re350-v1) ucidef_set_led_netdev "wifi2g" "Wifi 2.4G" "$boardname:blue:wifi2G" "wlan0" ucidef_set_led_netdev "wifi5g" "Wifi 5G" "$boardname:blue:wifi5G" "wlan1" ucidef_set_led_netdev "eth_act" "LAN act" "$boardname:green:eth_act" "lan" "tx rx" ucidef_set_led_netdev "eth_link" "LAN link" "$boardname:green:eth_link" "lan" "link" ;; -tplink,re500-v1) +tplink,re500-v1|\ +tplink,re650-v1) ucidef_set_led_netdev "eth_act" "LAN act" "$boardname:green:eth_act" "lan" "tx rx" ucidef_set_led_netdev "eth_link" "LAN link" "$boardname:green:eth_link" "lan" "link" ;;