From: Chris Morgan Date: Wed, 11 Mar 2020 21:00:42 +0000 (-0500) Subject: ath79: add support for Comfast CF-EW72 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=7daab6286110b95167e291409395494f18edc9dc;p=openwrt%2Fstaging%2Faparcar.git ath79: add support for Comfast CF-EW72 Specifications: Qualcomm/Atheros QCA9531 + QCA9886 2x 10/100 Mbps Ethernet, with 48v PoE 2T2R 2.4 GHz, 802.11b/g/n 2T2R 5 GHz, 802.11a/n/ac 128MB RAM 16MB SPI Flash 4x LED (Always On Power, LAN, WAN, WLAN) Flashing Instructions: Original firmware is based on OpenWRT, so flashing the sysupgrade image on the factory firmware is sufficient. Tested: Reset button, WAN LED, LAN LED, Power LED (always on, not much to test), WLAN LED (one LED only for 2 interfaces, by default it gets assigned to the first interface), MAC addresses (match factory firmware). My LAN factory MAC address ends in F2. use stock_mac art_loc lan :f2 0x0 wan :f3 0x1002 5g :f4 0x6 2g :f5 0x5006 Since MAC address flash locations do not really match their use in vendor firmware (e.g. address from 5 GHz calibration data is assigned to 2.4 GHz WiFi), just calculate the MAC addresses with an offset based on 0x0 address. Signed-off-by: Chris Morgan [add MAC address comment] Signed-off-by: Adrian Schmutzler --- diff --git a/target/linux/ath79/dts/qca9531_comfast_cf-ew72.dts b/target/linux/ath79/dts/qca9531_comfast_cf-ew72.dts new file mode 100644 index 0000000000..06c8f0737e --- /dev/null +++ b/target/linux/ath79/dts/qca9531_comfast_cf-ew72.dts @@ -0,0 +1,132 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca953x.dtsi" + +/ { + compatible = "comfast,cf-ew72", "qca,qca9531"; + model = "COMFAST CF-EW72"; + + aliases { + serial0 = &uart; + led-boot = &led_wan; + led-failsafe = &led_wan; + led-upgrade = &led_wan; + }; + + leds { + compatible = "gpio-leds"; + + pinctrl-names = "default"; + pinctrl-0 = <&jtag_disable_pins>; + + lan { + label = "cf-ew72:blue:lan"; + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; + }; + + led_wan: wan { + label = "cf-ew72:blue:wan"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; + + wlan { + label = "cf-ew72:blue:wlan"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tpt"; + }; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + linux,code = ; + gpios = <&gpio 17 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; + + watchdog { + compatible = "linux,wdt-gpio"; + + gpios = <&gpio 13 GPIO_ACTIVE_LOW>; + hw_algo = "toggle"; + hw_margin_ms = <1200>; + always-running; + }; +}; + +&pcie0 { + status = "okay"; +}; + +&spi { + status = "okay"; + + num-cs = <1>; + + flash@0 { + compatible = "winbond,w25q128", "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x010000>; + read-only; + }; + + art: partition@10000 { + label = "art"; + reg = <0x010000 0x010000>; + read-only; + }; + + partition@20000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x020000 0xfd0000>; + }; + + partition@ff0000 { + label = "nvram"; + reg = <0xff0000 0x010000>; + read-only; + }; + }; + }; +}; + +&uart { + status = "okay"; +}; + +ð0 { + status = "okay"; + + phy-handle = <&swphy4>; + mtd-mac-address = <&art 0x0>; + mtd-mac-address-increment = <1>; +}; + +ð1 { + mtd-mac-address = <&art 0x0>; +}; + +&wmac { + status = "okay"; + + mtd-cal-data = <&art 0x1000>; + mtd-mac-address = <&art 0x0>; + mtd-mac-address-increment = <3>; +}; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds index 046339aa0a..8e84ca25bf 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds @@ -80,6 +80,10 @@ comfast,cf-e560ac) ucidef_set_led_switch "lan3" "LAN3" "$boardname:blue:lan3" "switch0" "0x08" ucidef_set_led_switch "lan4" "LAN4" "$boardname:blue:lan4" "switch0" "0x10" ;; +comfast,cf-ew72) + ucidef_set_led_switch "lan" "LAN" "$boardname:blue:lan" "switch0" "0x02" + ucidef_set_led_netdev "wan" "WAN" "$boardname:blue:wan" "eth1" + ;; devolo,magic-2-wifi) ucidef_set_led_netdev "plcw" "dLAN" "devolo:white:dlan" "eth0.1" "rx" ;; diff --git a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata index d354c7eaec..18bdfa2b22 100644 --- a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata +++ b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/11-ath10k-caldata @@ -140,7 +140,8 @@ case "$FIRMWARE" in /lib/firmware/ath10k/QCA9888/hw2.0/board.bin rm /lib/firmware/ath10k/QCA9888/hw2.0/board-2.bin ;; - comfast,cf-e560ac) + comfast,cf-e560ac|\ + comfast,cf-ew72) caldata_extract "art" 0x5000 0x2f20 ath10k_patch_mac $(macaddr_add $(mtd_get_mac_binary art 0x0) +2) ln -sf /lib/firmware/ath10k/pre-cal-pci-0000\:00\:00.0.bin \ diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index aac89e9269..87586492be 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -326,6 +326,16 @@ define Device/comfast_cf-e560ac endef TARGET_DEVICES += comfast_cf-e560ac +define Device/comfast_cf-ew72 + SOC := qca9531 + DEVICE_VENDOR := COMFAST + DEVICE_MODEL := CF-EW72 + DEVICE_PACKAGES := kmod-usb2 kmod-ath10k-ct ath10k-firmware-qca9888-ct \ + -uboot-envtools -swconfig + IMAGE_SIZE := 16192k +endef +TARGET_DEVICES += comfast_cf-ew72 + define Device/comfast_cf-wr650ac-v1 SOC := qca9558 DEVICE_VENDOR := COMFAST