From: Maxime Chevallier Date: Fri, 9 Nov 2018 08:17:33 +0000 (+0100) Subject: net: mvneta: Don't advertise 2.5G modes X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=83e65df6dfece9eb588735459428f221eb930c0c;p=openwrt%2Fstaging%2Fblogic.git net: mvneta: Don't advertise 2.5G modes Using 2.5G speed relies on the SerDes lanes being configured accordingly. The lanes have to be reconfigured to switch between 1G and 2.5G, and for now only the bootloader does this configuration. In the case we add a Comphy driver to handle switching the lanes dynamically, it's better for now to stick with supporting only 1G and add advertisement for 2.5G once we really are capable of handling both speeds without problem. Since the interface mode is initialy taken from the DT, we want to make sure that adding comphy support won't break boards that don't update their dtb. Fixes: da58a931f248 ("net: mvneta: Add support for 2500Mbps SGMII") Reported-by: Andrew Lunn Reported-by: Russell King Signed-off-by: Maxime Chevallier Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/marvell/mvneta.c b/drivers/net/ethernet/marvell/mvneta.c index 3ba672e9e353..e5397c8197b9 100644 --- a/drivers/net/ethernet/marvell/mvneta.c +++ b/drivers/net/ethernet/marvell/mvneta.c @@ -3343,7 +3343,6 @@ static void mvneta_validate(struct net_device *ndev, unsigned long *supported, if (state->interface != PHY_INTERFACE_MODE_NA && state->interface != PHY_INTERFACE_MODE_QSGMII && state->interface != PHY_INTERFACE_MODE_SGMII && - state->interface != PHY_INTERFACE_MODE_2500BASEX && !phy_interface_mode_is_8023z(state->interface) && !phy_interface_mode_is_rgmii(state->interface)) { bitmap_zero(supported, __ETHTOOL_LINK_MODE_MASK_NBITS); @@ -3357,14 +3356,9 @@ static void mvneta_validate(struct net_device *ndev, unsigned long *supported, /* Asymmetric pause is unsupported */ phylink_set(mask, Pause); - /* We cannot use 1Gbps when using the 2.5G interface. */ - if (state->interface == PHY_INTERFACE_MODE_2500BASEX) { - phylink_set(mask, 2500baseT_Full); - phylink_set(mask, 2500baseX_Full); - } else { - phylink_set(mask, 1000baseT_Full); - phylink_set(mask, 1000baseX_Full); - } + /* Half-duplex at speeds higher than 100Mbit is unsupported */ + phylink_set(mask, 1000baseT_Full); + phylink_set(mask, 1000baseX_Full); if (!phy_interface_mode_is_8023z(state->interface)) { /* 10M and 100M are only supported in non-802.3z mode */