From: Adrian Schmutzler Date: Fri, 16 Aug 2019 10:59:09 +0000 (+0200) Subject: ramips: initialize MAC addresses from flash where possible X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=aaf90d88087d7d23b1b829bef5012cc0a0b5ed4c;p=openwrt%2Fstaging%2Fthess.git ramips: initialize MAC addresses from flash where possible This patch changes wan MAC address setup from retrieving it by calculation to reading it from flash. Changes are limited to cases where on-device check was possible. Signed-off-by: Adrian Schmutzler [fix mac for newifi-d1; drop adslr,g7 because it's unlikely for vendor to specifically use 2.4g mac as wan_mac] Signed-off-by: Chuanhong Guo --- diff --git a/target/linux/ramips/base-files/etc/board.d/02_network b/target/linux/ramips/base-files/etc/board.d/02_network index 8c6c55d7b7..b80041c2ab 100755 --- a/target/linux/ramips/base-files/etc/board.d/02_network +++ b/target/linux/ramips/base-files/etc/board.d/02_network @@ -515,7 +515,8 @@ ramips_setup_macs() netgear,wnce2001|\ ohyeah,oy-0001|\ phicomm,k2g|\ - skylab,skw92a) + skylab,skw92a|\ + totolink,lr1200) wan_mac=$(mtd_get_mac_binary factory 0x2e) ;; dlink,dir-300-b7|\ @@ -536,12 +537,18 @@ ramips_setup_macs() wan_mac=$(macaddr_add "$lan_mac" 1) ;; asus,rt-ac57u|\ + d-team,newifi-d2|\ + d-team,pbr-m1|\ elecom,wrc-1167ghbk2-s|\ elecom,wrc-1900gst|\ elecom,wrc-2533gst|\ + lenovo,newifi-d1|\ phicomm,k2p|\ planex,vr500|\ - samknows,whitebox-v8) + samknows,whitebox-v8|\ + youku,yk-l2|\ + zbtlink,zbt-we1326|\ + zbtlink,zbt-we3526) wan_mac=$(mtd_get_mac_binary factory 0xe006) ;; asus,rt-n56u) @@ -625,9 +632,6 @@ ramips_setup_macs() iptime,a604m) wan_mac=$(mtd_get_mac_binary u-boot 0x1fc40) ;; - lenovo,newifi-d1) - lan_mac=$(macaddr_add "$(cat /sys/class/net/eth0/address)" 2) - ;; linksys,e1700) wan_mac=$(mtd_get_mac_ascii config WAN_MAC_ADDR) ;;