From: John Keeping Date: Fri, 24 Feb 2017 12:55:00 +0000 (+0000) Subject: drm/rockchip: dw-mipi-dsi: improve PLL configuration X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=b0a45fec5974f84aff7c249f7da6674f81b61bf6;p=openwrt%2Fstaging%2Fblogic.git drm/rockchip: dw-mipi-dsi: improve PLL configuration The multiplication ratio for the PLL is required to be even due to the use of a "by 2 pre-scaler". Currently we are likely to end up with an odd multiplier even though there is an equivalent set of parameters with an even multiplier. For example, using the 324MHz bit rate with a reference clock of 24MHz we end up with M = 27, N = 2 whereas the example in the PHY databook gives M = 54, N = 4 for this bit rate and reference clock. By walking down through the available multiplier instead of up we are more likely to hit an even multiplier. With the above example we do now get M = 54, N = 4 as given by the databook. While doing this, change the loop limits to encode the actual limits on the divisor, which are: 40MHz >= (pllref / N) >= 5MHz Signed-off-by: John Keeping Reviewed-by: Sean Paul Signed-off-by: Sean Paul Link: http://patchwork.freedesktop.org/patch/msgid/20170224125506.21533-18-john@metanate.com --- diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c index 9b6a60deb69e..e6b52c7cb5e3 100644 --- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c +++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c @@ -518,7 +518,18 @@ static int dw_mipi_dsi_get_lane_bps(struct dw_mipi_dsi *dsi, pllref = DIV_ROUND_UP(clk_get_rate(dsi->pllref_clk), USEC_PER_SEC); tmp = pllref; - for (i = 1; i < 6; i++) { + /* + * The limits on the PLL divisor are: + * + * 5MHz <= (pllref / n) <= 40MHz + * + * we walk over these values in descreasing order so that if we hit + * an exact match for target_mbps it is more likely that "m" will be + * even. + * + * TODO: ensure that "m" is even after this loop. + */ + for (i = pllref / 5; i > (pllref / 40); i--) { pre = pllref / i; if ((tmp > (target_mbps % pre)) && (target_mbps / pre < 512)) { tmp = target_mbps % pre;