From: Bhadram Varka Date: Sun, 17 Jun 2018 14:32:05 +0000 (+0530) Subject: stmmac: fix DMA channel hang in half-duplex mode X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=b6cfffa7ad923c73f317ea50fd4ebcb3b4b6669c;p=openwrt%2Fstaging%2Fblogic.git stmmac: fix DMA channel hang in half-duplex mode HW does not support Half-duplex mode in multi-queue scenario. Fix it by not advertising the Half-Duplex mode if multi-queue enabled. Signed-off-by: Bhadram Varka Signed-off-by: David S. Miller --- diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c index e79b0d7b388a..cba46b62a1cd 100644 --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c @@ -928,6 +928,7 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv) static int stmmac_init_phy(struct net_device *dev) { struct stmmac_priv *priv = netdev_priv(dev); + u32 tx_cnt = priv->plat->tx_queues_to_use; struct phy_device *phydev; char phy_id_fmt[MII_BUS_ID_SIZE + 3]; char bus_id[MII_BUS_ID_SIZE]; @@ -968,6 +969,15 @@ static int stmmac_init_phy(struct net_device *dev) phydev->advertising &= ~(SUPPORTED_1000baseT_Half | SUPPORTED_1000baseT_Full); + /* + * Half-duplex mode not supported with multiqueue + * half-duplex can only works with single queue + */ + if (tx_cnt > 1) + phydev->supported &= ~(SUPPORTED_1000baseT_Half | + SUPPORTED_100baseT_Half | + SUPPORTED_10baseT_Half); + /* * Broken HW is sometimes missing the pull-up resistor on the * MDIO line, which results in reads to non-existent devices returning