From: Nicholas Smith Date: Fri, 3 Jul 2020 23:09:08 +0000 (+1000) Subject: ath79: add support for Telco T1 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=c00b8dcf72b5df6137e2726cf40645abe188d57a;p=openwrt%2Fstaging%2Fynezz.git ath79: add support for Telco T1 Description: 2x 100Mbps Etherent ports 24V passive PoE 64MB RAM 16MB Flash 2.4GHz WiFi 1x WiFi antenna (RP-SMA connector) 1x LTE antenna (SMA connector) Sierra Wireless MC7430 LTE modem Flash instructions: Original firmware is based on OpenWrt. Flash using sysupgrade -n SUPPORTED_DEVICES is added to support factory firmware. Signed-off-by: Nicholas Smith [add missing led_rssi0 DT label, add SUPPORTED_DEVICES] Signed-off-by: Adrian Schmutzler --- diff --git a/target/linux/ath79/dts/qca9531_telco_t1.dts b/target/linux/ath79/dts/qca9531_telco_t1.dts new file mode 100644 index 0000000000..25a97edfca --- /dev/null +++ b/target/linux/ath79/dts/qca9531_telco_t1.dts @@ -0,0 +1,144 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca953x.dtsi" + +/ { + compatible = "telco,t1", "qca,qca9531"; + model = "Telco T1"; + + aliases { + label-mac-device = ð0; + led-boot = &led_rssi0; + led-failsafe = &led_rssi0; + led-running = &led_rssi0; + led-upgrade = &led_rssi0; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + linux,code = ; + gpios = <&gpio 17 GPIO_ACTIVE_LOW>; + }; + }; + + leds { + compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&jtag_disable_pins &pinmux_led_wan_pin>; + + wan { + label = "t1:blue:wan"; + gpios = <&gpio 4 GPIO_ACTIVE_LOW>; + }; + + lan { + label = "t1:blue:lan"; + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; + }; + + wlan { + label = "t1:blue:wlan"; + gpios = <&gpio 0 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tpt"; + }; + + led_rssi0: rssi0 { + label = "t1:blue:rssi0"; + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; + }; + + rssi1 { + label = "t1:blue:rssi1"; + gpios = <&gpio 3 GPIO_ACTIVE_LOW>; + }; + + rssi2 { + label = "t1:blue:rssi2"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&uart { + status = "okay"; +}; + +&usb0 { + status = "okay"; +}; + +&usb_phy { + status = "okay"; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x000000 0x010000>; + read-only; + }; + + art: partition@10000 { + label = "art"; + reg = <0x010000 0x010000>; + read-only; + }; + + partition@20000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x020000 0xfd0000>; + }; + + partition@ff0000 { + label = "art-backup"; + reg = <0xff0000 0x010000>; + read-only; + }; + }; + }; +}; + +ð0 { + status = "okay"; + + mtd-mac-address = <&art 0x0>; + + phy-handle = <&swphy4>; +}; + +ð1 { + mtd-mac-address = <&art 0x6>; +}; + +&wmac { + status = "okay"; + + mtd-cal-data = <&art 0x1000>; +}; + +&pinmux { + pinmux_led_wan_pin: led_wan_pin { + pinctrl-single,bits = <0x4 0x0 0xff>; + }; +}; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/01_leds b/target/linux/ath79/generic/base-files/etc/board.d/01_leds index 1dff5acc38..4f1b76a65a 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/generic/base-files/etc/board.d/01_leds @@ -106,7 +106,8 @@ comfast,cf-e560ac) ucidef_set_led_switch "lan3" "LAN3" "$boardname:blue:lan3" "switch0" "0x08" ucidef_set_led_switch "lan4" "LAN4" "$boardname:blue:lan4" "switch0" "0x10" ;; -comfast,cf-ew72) +comfast,cf-ew72|\ +telco,t1) ucidef_set_led_switch "lan" "LAN" "$boardname:blue:lan" "switch0" "0x02" ucidef_set_led_netdev "wan" "WAN" "$boardname:blue:wan" "eth1" ;; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches b/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches index cc1b8ff412..cf30bb405a 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches +++ b/target/linux/ath79/generic/base-files/etc/board.d/03_gpio_switches @@ -25,7 +25,8 @@ adtran,bsap1840) ucidef_add_gpio_switch "wifi0_ext_c" "2.4GHz External Antenna C" "509" "1" ucidef_add_gpio_switch "wifi0_int_c" "2.4GHz Internal Antenna C" "510" ;; -comfast,cf-e5) +comfast,cf-e5|\ +telco,t1) ucidef_add_gpio_switch "lte_power" "LTE Power" "14" "1" ucidef_add_gpio_switch "lte_wakeup" "LTE Wakeup" "11" "1" ucidef_add_gpio_switch "lte_poweroff" "LTE Poweroff" "1" "1" diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index 6b7bfb4639..ee798bf321 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -1367,6 +1367,17 @@ define Device/sitecom_wlr-8100 endef TARGET_DEVICES += sitecom_wlr-8100 +define Device/telco_t1 + SOC := qca9531 + DEVICE_VENDOR := Telco + DEVICE_MODEL := T1 + DEVICE_PACKAGES := kmod-usb2 kmod-usb-net-qmi-wwan \ + kmod-usb-serial-option uqmi -swconfig -uboot-envtools + IMAGE_SIZE := 16192k + SUPPORTED_DEVICES += telco_electronics,tel-t1 +endef +TARGET_DEVICES += telco_t1 + define Device/teltonika_rut955 SOC := ar9344 DEVICE_VENDOR := Teltonika