From: Mark Brown Date: Fri, 25 Apr 2014 06:37:56 +0000 (-0700) Subject: Input: ads7877 - remove bitrotted comment X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=c728601ea3531dc1f0dcd74c1db1e85e59f2be68;p=openwrt%2Fstaging%2Fblogic.git Input: ads7877 - remove bitrotted comment While searching for users of spi_async() I found a reference in the ad7877 driver to using it to initiate data transfer from the interrupt handler. However there is no code for this, instead the interrupt handler is a threaded handler and uses spi_sync() instead. Remove the bitrotted comment, though in actual fact the use case mentioned is a great use for spi_async() since it would cut down on latency handling the interrupt by saving us a context switch before we start SPI. This was previously implemented, it was removed in commit b534422b2d11 (Input: ad7877 - switch to using threaded IRQ) for code complexity reasons. It may be better to revert that commit instead. Signed-off-by: Mark Brown Signed-off-by: Dmitry Torokhov --- diff --git a/drivers/input/touchscreen/ad7877.c b/drivers/input/touchscreen/ad7877.c index 6793c85903ae..523865daa1d3 100644 --- a/drivers/input/touchscreen/ad7877.c +++ b/drivers/input/touchscreen/ad7877.c @@ -210,11 +210,6 @@ static bool gpio3; module_param(gpio3, bool, 0); MODULE_PARM_DESC(gpio3, "If gpio3 is set to 1 AUX3 acts as GPIO3"); -/* - * ad7877_read/write are only used for initial setup and for sysfs controls. - * The main traffic is done using spi_async() in the interrupt handler. - */ - static int ad7877_read(struct spi_device *spi, u16 reg) { struct ser_req *req;