From: David Bauer Date: Sun, 12 Jan 2020 19:20:43 +0000 (+0100) Subject: ath79: add support for D-Link DIR-505 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=c9ac7b17296ff29d9df39db8a68c449ef1514bbd;p=openwrt%2Fstaging%2Fyousong.git ath79: add support for D-Link DIR-505 This commit adds support for the D-Link DIR-505, previously supported in ar71xx. Hardware -------- SoC: Atheros AR9330 FLASH: 8M SPI-NOR RAM: 64M WIFI: 1T1R 1SS Atheros AR9330 LED: Power green, Status red BTN: WPS, Reset Installation ------------ Currently, installation is only possible by sysupgrading from an earlier OpenWrt version, U-Boot TFTP or a modded U-Boot. I do not have the original bootloader from D-Link on my device anymore, so i cannot test the factory image. Signed-off-by: David Bauer --- diff --git a/target/linux/ath79/dts/ar9330_dlink_dir-505.dts b/target/linux/ath79/dts/ar9330_dlink_dir-505.dts new file mode 100644 index 0000000000..6984176daa --- /dev/null +++ b/target/linux/ath79/dts/ar9330_dlink_dir-505.dts @@ -0,0 +1,149 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "ar9330.dtsi" + +/ { + model = "D-Link DIR-505"; + compatible = "dlink,dir-505", "qca,ar9330"; + + aliases { + serial0 = &uart; + led-boot = &led_power_green; + led-failsafe = &led_status_red; + led-running = &led_power_green; + led-upgrade = &led_status_red; + }; + + keys { + compatible = "gpio-keys"; + + wps { + label = "WPS button"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + linux,code = ; + }; + + reset { + label = "Reset button"; + gpios = <&gpio 12 GPIO_ACTIVE_HIGH>; + linux,code = ; + }; + }; + + leds { + compatible = "gpio-leds"; + pinctrl-names = "default"; + pinctrl-0 = <&jtag_disable_pins>; + + led_power_green: power { + label = "d-link:green:power"; + gpios = <&gpio 27 GPIO_ACTIVE_LOW>; + }; + + led_status_red: status { + label = "d-link:red:status"; + gpios = <&gpio 26 GPIO_ACTIVE_LOW>; + }; + }; +}; + +&uart { + status = "okay"; +}; + +&gpio { + status = "okay"; + + led_enable { + gpio-hog; + output-low; + gpios = <1 GPIO_ACTIVE_LOW>; + line-name = "d-link:power:led"; + }; +}; + +&usb { + dr_mode = "host"; + status = "okay"; +}; + +&usb_phy { + status = "okay"; +}; + +ð0 { + status = "okay"; + + gmac-config { + device = <&gmac>; + switch-phy-addr-swap = <0>; + switch-phy-swap = <0>; + }; +}; + +ð1 { + compatible = "syscon", "simple-mfd"; + status = "okay"; +}; + +&spi { + num-chipselects = <1>; + status = "okay"; + + flash@0 { + compatible = "jedec,spi-nor"; + spi-max-frequency = <50000000>; + reg = <0>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "u-boot"; + reg = <0x0 0x10000>; + read-only; + }; + + art: partition@10000 { + label = "art"; + reg = <0x10000 0x10000>; + read-only; + }; + + mac: partition@20000 { + label = "mac"; + reg = <0x20000 0x10000>; + read-only; + }; + + partition@30000 { + label = "nvram"; + reg = <0x30000 0x10000>; + read-only; + }; + + partition@40000 { + label = "language"; + reg = <0x40000 0x40000>; + read-only; + }; + + partition@80000 { + compatible = "denx,uimage"; + label = "firmware"; + reg = <0x80000 0x780000>; + }; + }; + }; +}; + +&wmac { + status = "okay"; + qca,no-eeprom; +}; diff --git a/target/linux/ath79/generic/base-files/etc/board.d/02_network b/target/linux/ath79/generic/base-files/etc/board.d/02_network index 2bf5751a5c..a96b504d5a 100755 --- a/target/linux/ath79/generic/base-files/etc/board.d/02_network +++ b/target/linux/ath79/generic/base-files/etc/board.d/02_network @@ -18,6 +18,7 @@ ath79_setup_interfaces() devolo,dvl1750c|\ devolo,dvl1750i|\ devolo,dvl1750x|\ + dlink,dir-505|\ engenius,ecb1750|\ glinet,gl-ar300m-lite|\ netgear,ex6400|\ @@ -315,6 +316,9 @@ ath79_setup_macs() lan_mac=$(mtd_get_mac_text "caldata" 0xffa0) wan_mac=$(mtd_get_mac_text "caldata" 0xffb4) ;; + dlink,dir-505) + lan_mac=$(mtd_get_mac_text "mac" 0x4) + ;; dlink,dir-825-c1|\ dlink,dir-835-a1) lan_mac=$(mtd_get_mac_text "mac" 0x4) diff --git a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom index 84d840569b..4158116256 100644 --- a/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom +++ b/target/linux/ath79/generic/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom @@ -12,6 +12,7 @@ case "$FIRMWARE" in avm,fritz4020) caldata_extract_reverse "urlader" 0x1541 0x440 ;; + dlink,dir-505|\ dlink,dir-825-c1|\ dlink,dir-835-a1) caldata_extract "art" 0x1000 0x440 diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk index abc6f96a80..800e1c7a7d 100644 --- a/target/linux/ath79/image/generic.mk +++ b/target/linux/ath79/image/generic.mk @@ -373,6 +373,16 @@ define Device/devolo_dvl1750x endef TARGET_DEVICES += devolo_dvl1750x +define Device/dlink_dir-505 + SOC := ar9330 + DEVICE_VENDOR := D-Link + DEVICE_MODEL := DIR-505 + IMAGE_SIZE := 7680k + DEVICE_PACKAGES := kmod-usb2 + SUPPORTED_DEVICES += dir-505-a1 +endef +TARGET_DEVICES += dlink_dir-505 + define Device/dlink_dir-825-b1 SOC := ar7161 DEVICE_VENDOR := D-Link