From: Sebastian Andrzej Siewior Date: Sun, 15 Feb 2015 17:32:16 +0000 (+0100) Subject: serial: 8250: Revert "tty: serial: 8250_core: read only RX if there is something... X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=ca8bb4aefb932e3da105f28cbfba36d57a931081;p=openwrt%2Fstaging%2Fblogic.git serial: 8250: Revert "tty: serial: 8250_core: read only RX if there is something in the FIFO" This reverts commit 0aa525d11859c1a4d5b78fdc704148e2ae03ae13. The conditional RX-FIFO read seems to cause spurious interrupts and we see just: |serial8250: too much work for irq29 The previous behaviour was "default" for decades and Marvell's 88f6282 SoC might not be the only that relies on it. Therefore the Omap fix is reverted for now. Fixes: 0aa525d11859 ("tty: serial: 8250_core: read only RX if there is something in the FIFO") Reported-By: Nicolas Schichan Debuged-By: Peter Hurley Signed-off-by: Sebastian Andrzej Siewior Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/tty/serial/8250/8250_core.c b/drivers/tty/serial/8250/8250_core.c index e3b9570a1eff..deae122c9c4b 100644 --- a/drivers/tty/serial/8250/8250_core.c +++ b/drivers/tty/serial/8250/8250_core.c @@ -2138,8 +2138,8 @@ int serial8250_do_startup(struct uart_port *port) /* * Clear the interrupt registers. */ - if (serial_port_in(port, UART_LSR) & UART_LSR_DR) - serial_port_in(port, UART_RX); + serial_port_in(port, UART_LSR); + serial_port_in(port, UART_RX); serial_port_in(port, UART_IIR); serial_port_in(port, UART_MSR); @@ -2300,8 +2300,8 @@ dont_test_tx_en: * saved flags to avoid getting false values from polling * routines or the previous session. */ - if (serial_port_in(port, UART_LSR) & UART_LSR_DR) - serial_port_in(port, UART_RX); + serial_port_in(port, UART_LSR); + serial_port_in(port, UART_RX); serial_port_in(port, UART_IIR); serial_port_in(port, UART_MSR); up->lsr_saved_flags = 0; @@ -2394,8 +2394,7 @@ void serial8250_do_shutdown(struct uart_port *port) * Read data port to reset things, and then unlink from * the IRQ chain. */ - if (serial_port_in(port, UART_LSR) & UART_LSR_DR) - serial_port_in(port, UART_RX); + serial_port_in(port, UART_RX); serial8250_rpm_put(up); del_timer_sync(&up->timer);