From: Sven Roederer Date: Sun, 24 Mar 2019 23:03:19 +0000 (+0100) Subject: ath79: add TP-Link WR842N v3 X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=e0d98e120a94b75f63066d7abc6a392996ccb284;p=openwrt%2Fstaging%2Fblogic.git ath79: add TP-Link WR842N v3 This adds support for the TP-Link WR842N v3 which is already supported on ar71xx target (0b45bec22c59cc6e6b2fa71dc9a88386c5587132). Specification: * SoC: QCA9533 ver 2 rev 0 * 16 MB Flash (gd25q128) * 64 MB RAM * 1 WAN 10/100 MBit/s (blue connector) * 4 LAN 10/100 MBit/s (AR8229; 4 ports; yellow connectors) * Atheros AR9531 (2,4GHz, two fixed antennas) * USB * Reset / WPS button * WiFi button (rf kill) * 8 green leds; 1 red/green led * serial console (115200 8N1, according to the OpenWrt-wiki some soldering is needed) Installation: * flash via vendor WebUI (the filename must not exceed certain length) * sysupgrade from installed OpenWrt (also ar71xx) Thanks to Holger Drefs for providing the hardware Tested-by: @kofec (github) Signed-off-by: Sven Roederer --- diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds index af26425da2a3..9c353baabef0 100755 --- a/target/linux/ath79/base-files/etc/board.d/01_leds +++ b/target/linux/ath79/base-files/etc/board.d/01_leds @@ -163,7 +163,8 @@ tplink,tl-wr842n-v2) ucidef_set_led_switch "lan4" "LAN4" "tp-link:green:lan4" "switch0" "0x02" ;; tplink,tl-wr841-v9|\ -tplink,tl-wr841-v11) +tplink,tl-wr841-v11|\ +tplink,tl-wr842n-v3) ucidef_set_led_netdev "wan" "WAN" "tp-link:green:wan" "eth0" ucidef_set_led_switch "lan1" "LAN1" "tp-link:green:lan1" "switch0" "0x10" ucidef_set_led_switch "lan2" "LAN2" "tp-link:green:lan2" "switch0" "0x08" diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network index 2f4fb62a5f2a..f877669f98a2 100755 --- a/target/linux/ath79/base-files/etc/board.d/02_network +++ b/target/linux/ath79/base-files/etc/board.d/02_network @@ -180,6 +180,7 @@ ath79_setup_interfaces() tplink,tl-mr3420-v1|\ tplink,tl-wr841-v9|\ tplink,tl-wr841-v11|\ + tplink,tl-wr842n-v3|\ ubnt,airrouter) ucidef_set_interface_wan "eth0" ucidef_add_switch "switch0" \ diff --git a/target/linux/ath79/dts/qca9533_tplink_tl-wr842n-v3.dts b/target/linux/ath79/dts/qca9533_tplink_tl-wr842n-v3.dts new file mode 100644 index 000000000000..64be0744b283 --- /dev/null +++ b/target/linux/ath79/dts/qca9533_tplink_tl-wr842n-v3.dts @@ -0,0 +1,168 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT +/dts-v1/; + +#include +#include + +#include "qca953x.dtsi" + +/ { + compatible = "tplink,tl-wr842n-v3", "qca,qca9533"; + model = "TP-Link TL-WR842N v3"; + + aliases { + led-boot = &qss_led; + led-failsafe = &qss_led; + led-running = &qss_led; + led-upgrade = &qss_led; + }; + + gpio_leds: leds { + compatible = "gpio-leds"; + + system: power { + label = "tp-link:green:power"; + gpios = <&gpio 2 GPIO_ACTIVE_LOW>; + default-state = "on"; + }; + + wifi { + label = "tp-link:green:wlan"; + gpios = <&gpio 3 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tpt"; + }; + + qss_led: qss { + label = "tp-link:green:qss"; + gpios = <&gpio 17 GPIO_ACTIVE_LOW>; + }; + + wan_green { + label = "tp-link:green:wan"; + gpios = <&gpio 11 GPIO_ACTIVE_LOW>; + }; + + wan_red { + label = "tp-link:red:wan"; + gpios = <&gpio 4 GPIO_ACTIVE_LOW>; + }; + + lan1 { + label = "tp-link:green:lan1"; + gpios = <&gpio 12 GPIO_ACTIVE_LOW>; + }; + + lan2 { + label = "tp-link:green:lan2"; + gpios = <&gpio 13 GPIO_ACTIVE_LOW>; + }; + + lan3 { + label = "tp-link:green:lan3"; + gpios = <&gpio 14 GPIO_ACTIVE_LOW>; + }; + + lan4 { + label = "tp-link:green:lan4"; + gpios = <&gpio 15 GPIO_ACTIVE_LOW>; + }; + + usb { + label = "tp-link:green:usb"; + gpios = <&gpio 16 GPIO_ACTIVE_LOW>; + linux,default-trigger = "usbport"; + trigger-sources = <&hub_port>; + }; + }; + + keys { + compatible = "gpio-keys"; + + reset { + label = "Reset button"; + linux,code = ; + gpios = <&gpio 1 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + + rfkill { + label = "RFKILL button"; + linux,code = ; + gpios = <&gpio 0 GPIO_ACTIVE_LOW>; + debounce-interval = <60>; + }; + }; +}; + +&uart { + status = "okay"; +}; + +&usb0 { + #address-cells = <1>; + #size-cells = <0>; + status = "okay"; + + hub_port: port@1 { + reg = <1>; + #trigger-source-cells = <0>; + }; +}; + +&usb_phy { + status = "okay"; +}; + +&spi { + status = "okay"; + num-cs = <1>; + + flash@0 { + compatible = "jedec,spi-nor"; + reg = <0>; + spi-max-frequency = <25000000>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + uboot: partition@0 { + label = "u-boot"; + reg = <0x000000 0x020000>; + read-only; + }; + + partition@20000 { + compatible = "tplink,firmware"; + label = "firmware"; + reg = <0x020000 0xfd0000>; + }; + + art: partition@ff0000 { + label = "ART"; + reg = <0xff0000 0x010000>; + read-only; + }; + }; + }; +}; + +ð1 { + mtd-mac-address = <&uboot 0x1fc00>; +}; + +ð0 { + status = "okay"; + phy-handle = <&swphy4>; + + mtd-mac-address = <&uboot 0x1fc00>; + mtd-mac-address-increment = <1>; +}; + +&wmac { + status = "okay"; + mtd-cal-data = <&art 0x1000>; + mtd-mac-address = <&uboot 0x1fc00>; +}; + diff --git a/target/linux/ath79/image/generic-tp-link.mk b/target/linux/ath79/image/generic-tp-link.mk index ecc34b88e038..6853f123414e 100644 --- a/target/linux/ath79/image/generic-tp-link.mk +++ b/target/linux/ath79/image/generic-tp-link.mk @@ -243,6 +243,16 @@ define Device/tplink_tl-wr842n-v2 endef TARGET_DEVICES += tplink_tl-wr842n-v2 +define Device/tplink_tl-wr842n-v3 + $(Device/tplink-16mlzma) + ATH_SOC := qca9533 + DEVICE_TITLE := TP-Link TL-WR842N v3 + DEVICE_PACKAGES := kmod-usb-core kmod-usb2 kmod-usb-ledtrig-usbport + TPLINK_HWID := 0x8420003 + SUPPORTED_DEVICES += tl-wr842n-v3 +endef +TARGET_DEVICES += tplink_tl-wr842n-v3 + define Device/tplink_tl-wr1043nd-v2 $(Device/tplink-8mlzma) ATH_SOC := qca9558