From: Robert Marko Date: Mon, 14 Aug 2023 11:50:47 +0000 (+0200) Subject: ipq40xx: meraki: define DTB load address X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=f1c80445bd7e3b2f7fc3e4c8136402b30834d4e9;p=openwrt%2Fstaging%2Flinusw.git ipq40xx: meraki: define DTB load address It seems that the Meraki bootloader does not respect the kernel ARM booting specification[1] that requires that address where DTB is located needs to be 64-bit aligned and often places the DTB on a non 64-bit aligned address and then kernel fails to find the DTB magic and fails to boot. Even worse, there is no prints until early printk is enabled and then its visible that kernel is trying to find the ATAG-s as DTB was not found or is invalid. Unifi 6 devices had the same issue and it can be solved by passing the load adress as part of the FIT image. It seems that the vendor was aware of the issue and is always relocating the DTB to 0x89000000, so lets just do the same. Now that booting is reliable, reenable default images for the Meraki MR33 and MR74 devices. Reviewed-by: Lech Perczak lech.perczak@gmail.com Signed-off-by: Robert Marko --- diff --git a/target/linux/ipq40xx/image/generic.mk b/target/linux/ipq40xx/image/generic.mk index 78fa22c234..907558302c 100644 --- a/target/linux/ipq40xx/image/generic.mk +++ b/target/linux/ipq40xx/image/generic.mk @@ -762,13 +762,13 @@ define Device/meraki_common SOC := qcom-ipq4029 BLOCKSIZE := 128k PAGESIZE := 2048 + DEVICE_DTS_LOADADDR := 0x89000000 DEVICE_PACKAGES := ath10k-firmware-qca9887-ct endef define Device/meraki_mr33 $(call Device/meraki_common) DEVICE_MODEL := MR33 - DEFAULT := n endef TARGET_DEVICES += meraki_mr33 @@ -776,7 +776,6 @@ define Device/meraki_mr74 $(call Device/meraki_common) DEVICE_MODEL := MR74 DEVICE_DTS_CONFIG := config@3 - DEFAULT := n endef TARGET_DEVICES += meraki_mr74