From: Linus Walleij Date: Mon, 18 Mar 2019 15:31:22 +0000 (+0100) Subject: ARM: dts: nomadik: Fix polarity of SPI CS X-Git-Url: http://git.cdn.openwrt.org/?a=commitdiff_plain;h=fa9463564e77067df81b0b8dec91adbbbc47bfb4;p=openwrt%2Fstaging%2Fblogic.git ARM: dts: nomadik: Fix polarity of SPI CS The SPI DT bindings are for historical reasons a pitfall, the ability to flag a GPIO line as active high/low with the second cell flags was introduced later so the SPI subsystem will only accept the bool flag spi-cs-high to indicate that the line is active high. It worked by mistake, but the mistake was corrected in another commit. The comment in the DTS file was also misleading: this CS is indeed active high. Fixes: cffbb02dafa3 ("ARM: dts: nomadik: Augment NHK15 panel setting") Signed-off-by: Linus Walleij Signed-off-by: Arnd Bergmann --- diff --git a/arch/arm/boot/dts/ste-nomadik-nhk15.dts b/arch/arm/boot/dts/ste-nomadik-nhk15.dts index 04066f9cb8a3..f2f6558a00f1 100644 --- a/arch/arm/boot/dts/ste-nomadik-nhk15.dts +++ b/arch/arm/boot/dts/ste-nomadik-nhk15.dts @@ -213,12 +213,13 @@ gpio-sck = <&gpio0 5 GPIO_ACTIVE_HIGH>; gpio-mosi = <&gpio0 4 GPIO_ACTIVE_HIGH>; /* - * It's not actually active high, but the frameworks assume - * the polarity of the passed-in GPIO is "normal" (active - * high) then actively drives the line low to select the - * chip. + * This chipselect is active high. Just setting the flags + * to GPIO_ACTIVE_HIGH is not enough for the SPI DT bindings, + * it will be ignored, only the special "spi-cs-high" flag + * really counts. */ cs-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>; + spi-cs-high; num-chipselects = <1>; /*