From 1d80415db64b54141ef02ae58bd2f273d0ac3c38 Mon Sep 17 00:00:00 2001 From: Chirantan Ekbote Date: Thu, 12 Jun 2014 00:18:48 +0900 Subject: [PATCH] clocksource: exynos_mct: Don't reset the counter during boot and resume Unfortunately on some exynos systems, resetting the mct counter also resets the architected timer counter. This can cause problems if the architected timer driver has already been initialized because the kernel will think that the counter has wrapped around, causing a big jump in printk timestamps and delaying any scheduled clock events until the counter reaches the value it had before it was reset. The kernel code makes no assumptions about the initial value of the mct counter so there is no reason from a software perspective to clear the counter before starting it. This also fixes the problems described in the previous paragraph. Cc: Olof Johansson Cc: Tomasz Figa Signed-off-by: Chirantan Ekbote Reviewed-by: Doug Anderson Tested-by: Doug Anderson Signed-off-by: Kukjin Kim --- drivers/clocksource/exynos_mct.c | 9 +++------ 1 file changed, 3 insertions(+), 6 deletions(-) diff --git a/drivers/clocksource/exynos_mct.c b/drivers/clocksource/exynos_mct.c index 8d6420013a04..f71d55f5e6e5 100644 --- a/drivers/clocksource/exynos_mct.c +++ b/drivers/clocksource/exynos_mct.c @@ -153,13 +153,10 @@ static void exynos4_mct_write(unsigned int value, unsigned long offset) } /* Clocksource handling */ -static void exynos4_mct_frc_start(u32 hi, u32 lo) +static void exynos4_mct_frc_start(void) { u32 reg; - exynos4_mct_write(lo, EXYNOS4_MCT_G_CNT_L); - exynos4_mct_write(hi, EXYNOS4_MCT_G_CNT_U); - reg = __raw_readl(reg_base + EXYNOS4_MCT_G_TCON); reg |= MCT_G_TCON_START; exynos4_mct_write(reg, EXYNOS4_MCT_G_TCON); @@ -181,7 +178,7 @@ static cycle_t exynos4_frc_read(struct clocksource *cs) static void exynos4_frc_resume(struct clocksource *cs) { - exynos4_mct_frc_start(0, 0); + exynos4_mct_frc_start(); } struct clocksource mct_frc = { @@ -200,7 +197,7 @@ static u64 notrace exynos4_read_sched_clock(void) static void __init exynos4_clocksource_init(void) { - exynos4_mct_frc_start(0, 0); + exynos4_mct_frc_start(); if (clocksource_register_hz(&mct_frc, clk_rate)) panic("%s: can't register clocksource\n", mct_frc.name); -- 2.30.2