From 3a6818c771671c34b090244c92ab5aea6176d6da Mon Sep 17 00:00:00 2001 From: Rohit kumar Date: Wed, 19 Sep 2018 11:41:21 +0530 Subject: [PATCH] ASoC: q6afe: dt-bindings: Update input range for qcom,sd-lines Input to qcom,sd-lines should be between 0 and 3 instead of 1 to 4 as 0 corresponds to BIT(0) which is MI2S_SD0 line. Bit 1 to 3 corresponds to SD1 to SD3 lines respectively. Updated documentation for the same. Signed-off-by: Rohit kumar Signed-off-by: Mark Brown --- .../devicetree/bindings/sound/qcom,q6afe.txt | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-) diff --git a/Documentation/devicetree/bindings/sound/qcom,q6afe.txt b/Documentation/devicetree/bindings/sound/qcom,q6afe.txt index a8179409c194..d74888b9f1bb 100644 --- a/Documentation/devicetree/bindings/sound/qcom,q6afe.txt +++ b/Documentation/devicetree/bindings/sound/qcom,q6afe.txt @@ -49,7 +49,7 @@ configuration of each dai. Must contain the following properties. Usage: required for mi2s interface Value type: Definition: Must be list of serial data lines used by this dai. - should be one or more of the 1-4 sd lines. + should be one or more of the 0-3 sd lines. - qcom,tdm-sync-mode: Usage: required for tdm interface @@ -137,42 +137,42 @@ q6afe@4 { prim-mi2s-rx@16 { reg = <16>; - qcom,sd-lines = <1 3>; + qcom,sd-lines = <0 2>; }; prim-mi2s-tx@17 { reg = <17>; - qcom,sd-lines = <2>; + qcom,sd-lines = <1>; }; sec-mi2s-rx@18 { reg = <18>; - qcom,sd-lines = <1 4>; + qcom,sd-lines = <0 3>; }; sec-mi2s-tx@19 { reg = <19>; - qcom,sd-lines = <2>; + qcom,sd-lines = <1>; }; tert-mi2s-rx@20 { reg = <20>; - qcom,sd-lines = <2 4>; + qcom,sd-lines = <1 3>; }; tert-mi2s-tx@21 { reg = <21>; - qcom,sd-lines = <1>; + qcom,sd-lines = <0>; }; quat-mi2s-rx@22 { reg = <22>; - qcom,sd-lines = <1>; + qcom,sd-lines = <0>; }; quat-mi2s-tx@23 { reg = <23>; - qcom,sd-lines = <2>; + qcom,sd-lines = <1>; }; }; }; -- 2.30.2