From 6b10bfc51c494e0a2b2c0871797a1d825da9997c Mon Sep 17 00:00:00 2001 From: Antoine Tenart Date: Fri, 1 Mar 2019 11:52:11 +0100 Subject: [PATCH] net: mvpp2: always disable both MACs when disabling a port This patch modifies the port_disable() helper to always disable both the GMAC and the XLG MAC when called. At boot time we do not know of a port was enabled in the firmware/bootloader, and if so what mode was used (hence which of the two MACs was used). This also help in implementing a logic where all blocks are disabled when not used, and only enabled regarding the current mode used on a given port. Signed-off-by: Antoine Tenart Signed-off-by: David S. Miller --- drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c index 908dfe86db92..e9cbbe871a1a 100644 --- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c +++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c @@ -1213,11 +1213,11 @@ static void mvpp2_port_disable(struct mvpp2_port *port) /* Disable & reset should be done separately */ val &= ~MVPP22_XLG_CTRL0_MAC_RESET_DIS; writel(val, port->base + MVPP22_XLG_CTRL0_REG); - } else { - val = readl(port->base + MVPP2_GMAC_CTRL_0_REG); - val &= ~(MVPP2_GMAC_PORT_EN_MASK); - writel(val, port->base + MVPP2_GMAC_CTRL_0_REG); } + + val = readl(port->base + MVPP2_GMAC_CTRL_0_REG); + val &= ~(MVPP2_GMAC_PORT_EN_MASK); + writel(val, port->base + MVPP2_GMAC_CTRL_0_REG); } /* Set IEEE 802.3x Flow Control Xon Packet Transmission Mode */ -- 2.30.2